SJCam SJ4000 WiFi Manual
GENERAL NOTES
When you open the camera package for the first time check the contents to make sure you have all
the mounting hardware and accessories.
Plastic film covers the camera display and lens. There is also plastic film on the inside and outside of
the lens cover and both back cover doors of the clear housing. Remove plastic filmbefore using the
camera.
Verify the authenticity of the camera by checking the security code under the scratch-off on the side
of the package. Go to the SJCam official website at http://www.sjcamhd.com/safe/ and enter the
security code as directed to verify that you have an authentic SJCam.
This manual is based on firmware version G20150408V02 dated 2015 April 8. Camera menus, settings
or other operations might vary with other firmware versions.
Notes are identified in parentheses () and are described at the end of each section.
EXTERNAL LIGHTS
The following lights indicate the operation described and can occur in several combinations.
Blue light on:
camera is on.
Red light on:
camera is connected to a charger.
Amber light on:
camera is connected to a smart device via WiFi.
Blue light flashing:
camera is recording video.
Amber light flashing rapidly:
camera WiFi is turned on but not connected to a smart device.
Amber light flashing:
camera is connected to WiFi while recording video.
Red and amber lights on:WARNING – There is a serious problem with charging. Disconnect the
charger immediately due to the risk of severe overheating.
Blue light
Red light
Amber light
