instructions for
LED WORK SPOTLIGHT 12W/48W
model no:
WL12W, WL48W
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
1.1.
ELECTRICAL SAFETY
WARNING!
it is the responsibility of the owner and the operator to read, understand and comply with the following: You must check all
electrical products, before use, to ensure that they are safe. You must inspect power cables, plugs, sockets and any other connectors
for wear or damage.
9
ensure that cables are always protected against short circuit and overload.
9
regularly inspect power supply cables check all connections to ensure that none are loose.
Important:
ensure that the voltage marked on the appliance matches the power supply to be used and that the circuit is fitted with the
correct fuse. if in doubt, consult a qualified technician to connect the spotlight to a fused and switched dc supply.
8
DO NOT
pull or carry the spotlight by the power cable.
8
DO NOT
use worn or damaged cables, plugs or connectors. immediately have any faulty item repaired or replaced by a qualified
technician.
2. INTRODUCTION
Model No: WL12W
spotlight with 4 x 3W epistar™ high power leds producing up to 840 lumen output. iP67 rated with a powder coated die cast aluminium
housing. suitable replacement for traditional halogen work lights with up to 80% less power consumption. supplied with grade 304 stainless
steel mounting bracket and fixings.
Model No: WL48W
spotlight with 16 x 3W epistar™ high power leds producing up to 3450 lumen output. iP67 rated with a powder coated die cast aluminium
housing. suitable replacement for traditional halogen work lights with up to 12% less power consumption. supplied with grade 304 stainless
steel mounting bracket and fixings.
3. SPECIFICATION
Model No: ................................................................. WL12W
Power:. .............................................................................. 12W
lumen output:. ................................................................840lm
supply:. .....................................................................9-32V dc
dimension: ...................................................................Ø80mm
Model No: ................................................................. WL48W
Power:. .............................................................................. 48W
lumen output:. ..............................................................3450lm
supply:. .....................................................................9-32V dc
dimensions: ......................................................... 125 x 110mm
Wl12W, Wl48W | issue:2 (H,l) 16/01/18
Original Language Version
© Jack sealey limited
refer to
instruction
manual
Wl12W
Wl48W
m10
m8
