12W LITHIUM-ION RECHARGEABLE
SOLDERING IRON
MODEL NO:
SDL10
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING!
Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this
equipment, make sure you know where the nearest fire extinguisher is.
WARNING!
Always wear approved eye / face protection when operating the soldering iron.
WARNING!
Do not use the soldering iron if you notice damage to the workpiece.
WARNING!
Always point the soldering iron away from the eyes and body when during operation.
WARNING!
Do not put the soldering iron down, put it back in its holder.
WARNING!
Only use in a well ventilated area.
9
Keep flammable material away from the torch when operating.
8
DO NOT
operate the soldering iron when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT
use the soldering iron in an area where paint fumes, solvents or other flammable solids, liquids or gases pose a potential
hazard.
8
DO NOT
hold any workpiece by hand.
8
DO NOT
touch the workpiece close to the heated area as it will be very hot. Allow to cool.
8
DO NOT
operate the soldering iron if it is damaged as this may cause failure and/or possible personal injury.
8
DO NOT
touch the top of the soldering iron during or immediately after use, as it will be very hot. Allow to cool.
8
DO NOT
allow children to operate the soldering iron.
9
When not in use, store away from direct sunlight in a safe, dry, childproof location.
8
DO NOT
store at over 40°C, such as in a car in hot weather.
2. INTRODUCTION
Cordless and lightweight soldering iron. Inbuilt LED to illuminate soldering area in low light areas such as engine bays. Heats up to a
maximum temperature of 600°C and has a 40 minute working time.
3. SPECIFICATION
Model No.:..................................................................SDL10
Battery:
...................................................... 2.5Ah Lithium-ion
Charging time:
................................................................3.5hr
M
aximum Temperature: ............................................... 600
0
C
O
perating Time: ...........................................................
40min
Power Rating:
.................................................................
12W
4. CONTENTS
S
DL10 Issue 1 11/06/20
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Warning:
Hot surfaces
Do not cover
Wear eye
protection
I
tem
Description
Part number
1
Charging cord for SDL10
S
DL10.CC
2
Soldering stand for SDL10
S
DL10.S
3
12W Cone tip
S
DL11.CT
4
Transparent cap for SDL10 NOT SHOWN
S
DL10TC
Indoor use
only
fig.1
