tYRE INFLAtOR/MINI AIR COMPRESSOR WItH
WORKLIGHt 12V
mODEL NO:
MAC01
thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFEtY
9
Keep the
compressor clean and in good condition.
9
Replace or repair damaged parts.
Use recommended parts only. Unauthorised parts may be dangerous and will invalidate the
warranty.
9
Keep children and non-essential persons away from the work area.
WARNING!
This compressor is capable of producing a high pressure.
DO NOt
inflate any item beyond it’s maximum specified
pressure.
9
The 12volt cigarette lighter plug must not be replaced with any other type of plug or electrical supply.
8
DO NOt
use near flammable solids, liquids or gases.
8
DO NOt
direct inflation hose connector head at yourself, others or animals.
8
DO NOt
leave the compressor operating unattended. Always monitor it and the inflation pressure.
8
DO NOt
carry by the hose, or yank the hose from an inflation valve.
8
DO NOt
pull the plug from the cigarette lighter socket using the lead.
8
DO NOt
get the compressor wet or use in the rain.
8
DO NOt
use the compressor for a task that it is not designed for.
8
DO NOt
operate the compressor when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOt
operate the compressor if any parts are missing or the compressor is damaged, as this may cause failure and/or personal
injury.
8
DO NOt
open the unit.
2. INtRODuCtION
12V mini air compressor with delivery of 25lt/min. Integral storage for supply lead and air output hose. features work light for use in low light
areas. Light can also be set to flash for emergency use. Pressure gauge reads up to 8bar/120psi. Suitable for inflating tyres on cars, vans and
4x4s.
3. SPECIFICAtION
model no ....................................................................
MAC01
Hose length ................................................................
600mm
P
ower cord length .......................................................... 3.3m
max. current ......................................................
8.5A @ 40psi
Operating voltage .............................................................12V
Weight .........................................................................
1.05kg
T
ypical inflation time
.............
0-30psi in 178sec (175/70/R13)
4. OPERAtION
WARNING!
Ensure you have read and understood the safety instructions.
4.1.
Position compressor on a firm, flat surface and so that the air hose reaches the tyre valve.
4.2.
Check that the compressor On/Off switch is in the OFF position and plug the 12V plug into the vehicle’s cigarette lighter socket.
4.3.
Remove the valve dust cap and lift the connector locking lever into the upright position (fig.1).
4.4.
Push connector fully onto the valve and lock in place by pressing down the locking lever (fig.2).
IMPORtANt:
Inflation will only be effective if the connector is fully fitted and locked onto the valve.
4.5.
Press the compressor On/Off switch to the ON position and the compressor will begin to operate.
4.6.
Inflate the tyre to the desired pressure and turn off the compressor by pressing the switch to the OFF position.
NOtE:
The gauge may be subject to fluctuation whilst pumping.
4.7.
Remove the air hose from the tyre valve by releasing the locking lever and gently twisting and pulling the connector from the tyre
valve, taking care not to lose any air in the process. Replace the dust cap.
4.8.
Disconnect the 12V plug from the vehicle’s cigarette lighter socket.
WARNING!
The compressor must be switched off for fifteen minutes after each sixty minute period of continuous operation to prevent
excessive heat build-up.
Refer to
instruction
manual
Keep away
from rain
Original Language Version
© Jack Sealey Limited
fig.1
fig.2
m
AC01 | Issue:3 (H,2,F) 08/03/19
