XP-G2 CREE LED IntRInsICaLLy safE
HEaD toRCH
Model no:
Ht452Is
thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. safEty
WaRnInG!
Do not
change batteries in hazardous locations.
WaRnInG!
To reduce the risk of explosion
Do not
mix new batteries with used batteries, or mix batteries from different
manufacturers or from different types.
WaRnInG!
Remove the batteries when unused for a period of time to prevent battery leakage in the device.
9
The screw shall be secured tightly after opening and closing of the enclosure.
9
Substitution of components may impair the head torches intrinsic safety.
9
Clean the head torch only with damp cloth to avoid static electricity.
8
Do not
flash the light beam directly to humans eyes.
9
Always use the device following the regulations of each country.
2. IntRoDuCtIon
Single high power XP-G2 CRee led produces extremely bright, white light with an output of 216 lumens and a working range up to 100
metres. Two function on/off push button for high and low settings. Intrinsically safe for use in hazardous locations. lightweight, tough and
durable casing which will sustain high impacts and drops. Adjustable headband 90° rotatable head. Built-in gas release vent.
3. sPECIfICatIon
Model no: ................................................................Ht452Is
Battery: ...............................................3 x AAA (not included)
led Qty: ................................................1 CRee XP-G2 led
lumen output: ..................................High/low; 216lm/100lm
4. oPERatIon
4.1.
Push
the top button to operate. The sequence is high and then low mode (fig.1).
5. MaIntEnanCE
5.1.
BattERy REPLaCEMEnt (fIG.2):
5.1.1.
Remove the screws to gain access to the battery case (fig.2).
5.1.2.
Use only AAA batteries (not included).
5.1.3.
Clean the head torch only with damp cloth to avoid static electricity.
fig.1
fig.2
HT452IS Issue 1 15/08/19
Original Language Version
© Jack Sealey limited
Refer to
instructions
