1.1 ELECTRICAL SAFETY.
REGARDING DIRECT MAINS POWER USE WITH THE
CHARGING BASE AND PLUG ONLY.
WARNING!
It is the owner’s responsibility to read, understand
and comply with the following electrical instructions:
You must ensure the risk of electric shock is minimised by the
installation of appropriate safety devices. An RCCB (Residual
Current Circuit Breaker) should be incorporated in the main
distribution board. We also recommend that an RCD (Residual
Current Device) is used with all electrical products, particularly
portable equipment which is plugged into an electrical supply
not protected by an RCCB.
You must
also read and understand
the following instructions concerning electrical safety.
The Electricity At Work Act 1989 requires all portable
•
electrical appliances, if used on business premises, to be
tested by a qualified electrician, using a Portable
Appliance Tester (PAT), at least once a year.
The
•
Health & Safety at Work Act 1974
makes owners of
electrical appliances responsible for the safe condition of the
appliance, and the safety of the appliance operator.
If in any
doubt about electrical safety, contact a qualified electrician
Battery Charger Safety Instructions
•
WARNING!
DO NOT
use the charging base to charge any
battery other than that required for the tool. Other types of
batteries may explode!
Inspect the plug, cable and the charging base for wear
and damage to ensure items are safe before connecting to the
mains power supply. If worn or damaged
DO NOT
use,
immediately replace, or contact a qualified electrician.
Check cables are always protected against short circuit and
overload.
Uncoil the power cable between the plug and the charging base
before use.
DO NOT
pull or carry the charging base by the charger power
lead, or pull the plug from the mains socket by the power lead.
DO NOT
use any other type of transformer with the charging base.
DO NOT
try to open or dis-assemble the plug or charging base.
DO NOT
use the plug to power any other electrical item.
Disconnect the plug from the charging base and the mains
power supply when not in use.
DO NOT
expose the charging base to damp or wet conditions
(for indoor use only).
DO NOT
pull or carry the charging base by the power lead.
DO NOT
operate the charging base if it has been dropped, or
has received a sharp knock, or is damaged. Contact an
authorised service agent.
DO NOT
dismantle the charging base as this may cause
damage or personal injury and will invalidate your warranty.
DO NOT
insert foreign objects or material into the hole
reserved for the battery.
DO NOT
immediately charge a second battery. Consecutive
charging will overheat the charging base. Allow the unit to cool
for 15 minutes before charging the next battery.
Ensure that the insulation on all cables and on the appliance is
safe before connecting it to the power supply.
Ensure that cables are always protected against short circuit
and overload.
DO NOT
use worn or damaged cables, plugs or connectors.
Immediately have any faulty item repaired or replaced by a
qualified electrician.
When a BS1363/A UK 3 pin
plug is damaged, cut the cable
just above the plug and dispose
of the plug safely.
Fit a new plug according to the
following instructions (UK only).
a)
Connect the GREEN/
YELLOW earth wire to the
earth terminal ‘E’.
b)
Connect the BROWN live
wire to the live terminal ‘L’.
c)
Connect the BLUE neutral wire to the neutral terminal ‘N’.
d)
After wiring, check that there are no bare wires, that all
wires have been correctly connected, that the cable outer
insulation extends beyond the cable restraint and that the
restraint is tight. Double insulated products, which are always
marked with this symbol ,are fitted with live (brown) and
neutral (blue) wires only.
DO NOT
connect either wire to the earth terminal.
1.2 BATTERY SAFETY INSTRuCTIONS.
WARNING!
Battery contains lithium-ion which is dangerous.
Handle with care to avoid damage, fire, corrosion or personal
injury.
Charge battery prior to its first use. The battery will have
been shipped in a low charge state.
To reduce the risk of burns or fire:
DO NOT
Attempt to open, disassemble, modify or service the
battery pack.
DO NOT
Crush, puncture, short external contacts or dispose of
in fire or water.
DO NOT
Expose to temperatures above 40°C (104°).
Replace only with the battery pack designated for this product.
Recycle or dispose of used battery as stipulated by local
regulation.
Use only the charging base provided to charge the charger
battery.
DO NOT
attempt recharging the battery by means of an engine
generator or a DC power source.
WARNING!
Dispose of spent batteries correctly as they contain
Lithium-ion.
DANGER!
DO NOT
attempt to disassemble the
battery. For safety and environmental reasons
DO NOT
discard
in domestic waste or by burning. ONLY discard or recycle
according to local authority regulations.
WARNING!
DO NOT
allow a leaking battery to contact your
person. If you come into contact with battery liquid take the
following immediate action:
a) Skin contact:
Wash immediately with soap and water,
then wash flesh in either lemon juice or vinegar.
b) Eye contact:
Wash with a strong solution of boric acid,
and seek immediate medical attention.
1. SAFETY INSTRuCTIONS
CP40MC Issue: 1 - 06/07/09
INSTRUCTIONS FOR:
LITHIuM-ION 12V MAINS
CHARGER - 1 HOuR
MODEL No:
CP40MC
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly
maintained, give you years of trouble free performance.
IMPORTANT
:
PLEASE READ THESE INSTRuCTIONS CAREFuLLY. NOTE THE SAFE OPERATIONAL REQuIREMENTS, WARNINGS, AND
CAuTIONS. uSE THIS PRODuCT CORRECTLY, AND WITH CARE FOR THE PuRPOSE FOR WHICH IT IS INTENDED. FAILuRE TO DO SO MAY
CAuSE DAMAGE AND/OR PERSONAL INJuRY AND WILL INVALIDATE THE WARRANTY.
FuSE RATING
5 AMP
Blue
Neutral
Wire
Yellow & Green
Earth Wire
Cable
Restraint
