![background image](http://html1.mh-extra.com/html/sealey/500ttj/500ttj_instructions_1225247001.webp)
Refer to
instruction manual
WARNING: The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions
and situations that may occur. It must be understood that common sense and caution are factors which cannot be built into this
product, but must be applied by the operator.
WARNING!
Ensure all preliminary checks are carefully carried out before use of jack. Immediately repair or replace damaged
parts (use authorised service agent). Ensure use of
genuine parts only. Unauthorised parts may be dangerous and will invalidate
the warranty.
WARNING!
Use jack on level, solid ground, preferably concrete. Ensure the floor over which the jack will be transported is swept clean.
▲
DANGER!
DO NOT use on tarmacadam, or any other soft surface as jack may sink or topple. Serious injury may result if ignored.
▲
DANGER! If jack tips or leans STOP WHAT YOUR ARE DOING. MOVE QUICKLY TO A SAFE DISTANCE. DO NOT TRY TO HOLD
OR STEADY JACK.
Use
jack in a suitable work area. Keep the area clean and tidy and free from unrelated materials. Ensure there is adequate lighting.
Before use ensure the gearbox weight and size does not exceed the capacity of the jack.
Ensure the vehicle is raised and stabilised at the correct height before attempting to move the jack under the vehicle.
Ensure the jack saddle is fully lowered and is clean, dry, and oil free before attempting to transport the jack with or without a load.
Keep all unauthorised persons away from the jack during lifting and lowering and when in transit.
Maintain correct balance and footing. Ensure the floor is not slippery and wear no- slip shoes.
Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery, and contain and/or tie back long hair.
WARNING!
Ensure that the load is placed level and centrally on the jack saddle and that
it is fixed in place before attempting to lift, lower or transport the load.
The lowering speed will vary according to the weight of the load and the release valve setting.
Diligence is required in ensuring that you continually monitor the operation until completed.
Should the jack make any abnormal sounds during use,
STOP
IMMEDIATELY
and contact
your local service agent.
DO NOT
operate the jack if any parts are damaged or missing.
DO NOT
exceed the rated capacity of the jack.
DO NOT
raise/lower vehicle lifting platform whilst the transmission jack is being used.
DO NOT
transport the jack with/without a load, with the saddle in the raised position.
DO NOT
get the jack wet, or use it in damp or wet locations or areas where there is condensation.
DO NOT
operate the jack when you are tired or under the influence of alcohol, drugs or
intoxicating medication.
DO NOT
lift or support vehicles with the jack and do not use the jack as a load sustaining device.
DO NOT
use the jack for any purpose other than removal, transportation and the installation of
`
transmissions.
DO NOT
make any modifications to the jack.
DO NOT
adjust, or tamper with, the safety valve.
DO NOT
remove any labels from the jack. If the labels are damaged or unclear, replace them.
DO NOT
use brake fluid to top up the hydraulic unit.
Use Sealey hydraulic oil only.
Use a qualified person to to lubricate and maintain the jack.
Before storing the jack in a safe area, ensure that all parts, especially the saddle are clean and
free of grease and oil.
INSTRUCTIONS FOR:
TRANSMISSION JACK 0.5 TONNE
TELESCOPIC
MODEL No:
500TTJ
1. SAFETY
Telescopic 2-stage model for reduced clearance lifts. Featuring high-speed lift to gearbox. Foot pedal operation keeps hands free for aligning
saddle with transmission via saddle adjustment. Spring-loaded dead man's safety release control reduces the risk of inadvertent lowering.
Highly manoeuvrable on castors.
2. SPECIFICATION
Rated Capacity Stage 1/2 . . . . . . . 1000/500kg
Ram Extensions . . . . . . . . . . . . . . . . . . . . . . . .2
Minimum Saddle Height . . . . . . . . . . . . .890mm
Maximum Saddle Height . . . . . . . . . . .1875mm
Base Size . . . . . . . . . . . . . . . . .1000 x 1000mm
Fixed/Adjustable Saddle. . . . . . . . . . Adjustable
Saddle Tilt - Forward: . . . . . . . . . . . . . . . . . . 28°
Saddle Tilt - Backward: . . . . . . . . . . . . . . . . 22°
Saddle Adjustment - Left/Right: . . . . . . . .65mm
Original Language Version
500TTJ Issue: 3 (SP) - 15/07/15
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions and maintained properly, give you years of trouble free performance.
© Jack Sealey Limited