Assembly Instructions for VISIONMOUNT
TM
LCD Wall Mount Model: VMF
Thank you for choosing Sanus Systems wall mount furniture. This product is designed to mount VESA 75/100
LCD televisions up to 50 pounds onto a vertical wall. It allows you to effortlessly tilt your new television up to
15° up or down without the use of tools. Check carefully to make sure there are no missing or defective parts.
Never use defective parts. Improper installation may cause damage or serious injury. If you do not understand
these directions, or have any doubts about the safety of the installation, please call a qualified contractor or contact
Sanus at 800.359.5520 or www.sanus.com. We can quickly assist you with installation questions and missing
or damaged parts. Replacement parts for Sanus products purchased through authorized dealers will be shipped
directly to you.
Note:
The hardware provided is for wood stud walls only. If you are uncertain about the nature of your installa-
tion please consult a local contractor.
Required Tools:
Drill with 3/16” bit, Phillips screw driver
Supplied Parts:
(1) Wall Plate - a
(1) TV Mount Plate - b
(2) Glide - c
(1) Carriage Bolt and Washer - d, e
(1) Knob - f
(2) Wall Mount Screw - g (4) M4 Bolt - h
(1) Allen Key - i
Mounting the Wall Plate:
The Wall Plate (a)
MUST be mounted to a wood stud
. Use a high quality stud
sensor to locate a stud. It is a good idea to verify where the stud is located with an awl or thin nail. Use the Wall
Plate as a template to mark the two hole locations on the wall. Make sure these holes are aligned vertically and
centered over the stud. Pre-drill the two holes using a 3/16” drill bit. Attach the Wall Plate to the wall using the
two Wall Mount Screws (g) as shown in Diagram 1. Tighten the Wall Mount Screws until they protrude 1/4 inch
from the wall. You will firmly tighten the Wall Mount Screws during final assembly.
Diagram 1
a
g
06.29.05
