Samba MT, Manual

Page: 1 / 11

Samba MT Speaker Kit
Thank you for purchasing the Samba MT speaker kit. This speaker kit was precision cut using CNC
machinery for the best possible fit and finish. With a little time and patience, your finished product
will provide years of enjoyment. Please follow the following instructions for the best possible
results.
Suggested tools and consumables:
Drill Rag or paper towels
5/64" drill bit Solder
Wood clamps (you can never have too many of these) Soldering iron
Sanding block and/or electric finishing sander Hot glue gun
Wood glue Binding post/terminal cup
Speaker or hook-up wire Polyurethane glue (Gorilla Glue)
0.11" female disconnect terminal Cyanoacrylate Adhesive (super glue)
0.205" female disconnect terminal #6 x 3/4" Pan head wood screws
Package contents:
First, empty the contents of the package and review parts to ensure everything has been included
and is in good condition. If any parts are missing or damaged please contact our customer service
department at 1-800-338-0531.
Note: Crossover components may be substituted with parts of equal of higher quality
depending on stock.
Components:
A) 1 x Dayton Audio RS180P-4 7" Reference Paper Woofer 4 Ohm
B)
1 x Dayton Audio RST28F-4 1-1/8" Reference Series Fabric Dome Tweeter 4 Ohm
C) 1 x Port Tube 2" ID Adjustable