Quick Start Guide
Smart Relay – Low Voltage (SC824ZB)
I
N THE
B
OX
S
AFETY
I
NSTRUCTIONS
:
Read these instructions carefully
before installing and
using
the Smart Relay – Low Voltage and keep this guide
in a safe place for future reference.
•
Verify compatibility
with your associated
connected home system before installation.
•
Follow all instructions provided by your connected
home manufacturer regarding the addition of
devices to your connected home system. An
authorized, qualified installer may be required.
•
Follow all applicable codes and regulations in the
municipality where this product is installed.
Salus accepts no responsibility for damage caused by not
following these instructions.
Smart Relay - Low Voltage
Quick Start Guide
N
OTE
:
Additional equipment may be required to address
radio communication issues due to building
construction or materials, or other radio interference.
I
NSTALLATION
I
NSTRUCTIONS
:
W
ALL
B
OX
M
OUNTING
:
•
Remove the assembly from the carton.
•
Remove the front cover by lifting from the bottom.
•
Position the relay in the desired location.
If anchors are required:
•
Mark the locations of the screws.
•
Drill 3/16” holes.
•
Insert the anchors (provided)
•
Position the relay over the anchors.
•
Secure with 2 mounting screws (provided).
•
Wire relay as desired. See options below. Remove
knockout on bottom side panel if required.
•
Secure cables with the strain relief.
•
Replace the front cover.
S
URFACE
M
OUNTING
:
•
Remove the assembly from the carton.
•
Remove the front cover by lifting from the bottom.
•
Remove the Relay Retainer by lifting the corners.
•
Wire relay as desired. See options below.
•
Remove white/blank backing from adhesive
(provided).
•
Apply adhesive to bottom half of relay back.
•
Remove red lettered backing from adhesive.
•
Press back of relay onto the surface to be attached.
W
IRING
O
PTIONS
:
D
RY
C
ONTACT
C
ONNECTIONS
:
•
Power In to terminal R
•
Power Return to terminal C
•
Load Out to terminal OUT
•
Load Common to terminal COM
P
OWER
S
WITCH
C
ONNECTIONS
:
•
Power In to terminal R
•
Power Return to terminal C
•
Load Out to terminal OUT
•
Load Common to the open terminal C
•
Add a wire between the open terminal R and COM
OUT COM R R C C
18-30 VAC
LOAD OUT
LOAD COMMON
POWER IN
POWER RETURN
OUT COM R R C C
18-30 VAC
LOAD OUT
LOAD COMMON
POWER IN
POWER RETURN
