![background image](http://html1.mh-extra.com/html/rowenta/powerglide-steam-iron/powerglide-steam-iron_instructions-for-use_1493228001.webp)
Powerglide
Instructions for use
Description
A Spray nozzle
B Water filling inlet
C Variable steam control
with Self clean
(Depending on model)
D Spray button
E Burst of steam button
F Auto off indicator light
(Depending on model)
G Temperature control dial
H Flexible cord protector
I Power cord
J
Pilot light
K Stainless steel soleplate
L Transparent water tank
Rowenta Inc.
196 Boston Avenue
Tel.: (781)396-0600
Medford, MA 02155 U.S.A.
www.rowentausa.com
OFFICE LOCATION ONLY.
If your appliance needs service, ship the product to your nearest regional
service center. If in warranty, Rowenta will repair or replace the product at
their discretion. If the product is out of warranty, you will be advised of the
cost of repair before any work begins.
Our main service centers are listed below:
Turnpike Appliance
Authorized Appliance
3495A Lawson Blvd.
1644 West Ogden Ave.
Oceanside, NY 11572
Downers Grove, IL 60515
516-483-5596
630-852-1550
Service center information is subject to change.
Please visit our website at www.rowentausa.com or call our
service center
information line
at 781-306-4620. The information line provides current
service center information and listings in California.
IMPORTANT SAFETY INSTRUCTIONS
When using your iron, basic safety precautions should always be followed,
including the following:
Read all instructions before using the iron.
1. Use iron only for its intended use.
2. To protect against a risk of electric shock,
do not
immerse the iron in
water or other liquids.
3. The iron should always be turned to Min. before plugging or unplugging
from outlet. Never yank cord to disconnect from outlet, instead grasp
plug and pull to disconnect.
4. Do not allow cord to touch hot surfaces. Let iron cool completely before
putting away. Loop cord loosely around handle when storing.
5. Always disconnect iron from electrical outlet when filling iron with water
or emptying and when not in use.
6. Do not operate iron with a damaged cord or if the iron has been dropped
or damaged. To avoid the risk of electric shock, do not disassemble the
iron. Ship it to the nearest Rowenta Appliance Service Center for examina-
tion and repair. Incorrect reassembly can cause a risk of electric shock
when the iron is used.
7. Close supervision is necessary for any appliance being used by or near
children. Do not leave iron unattended while connected or on an ironing
board.
8. Burns can occur from touching hot metal parts, hot water or steam.
Use caution when you turn a steam iron upside down – there may be hot
water in the water tank.
9. The use of accessory attachments is not recommended by Rowenta and
may result in fire, electric shock or personal injury.
SPECIAL INSTRUCTIONS
0
1. This is a 1200 or 1400 watt appliance. To avoid a circuit overload, do not
operate another high wattage appliance on the same circuit.
0
2. If an extension cord is absolutely necessary, a 12-ampere cord should be
used. Cords rated for less amperage may overheat. Care should be taken
to arrange the cord so that it can not be pulled or tripped over.
0
3. After the iron has cooled, wrap the cord loosely around the handle.
0
4. Your Rowenta appliance is intended for household use only.
SAVE THESE INSTRUCTIONS
Burst of steam
8
To remove stubborn wrinkles
or press in a sharp crease, use
the burst of steam button. Press the
button firmly, a strong burst of
steam penetrates deep into the
fabric. Leave an interval of at least
four seconds between pressing the
burst of steam button. With water
in the tank, the burst of steam
button can be used as soon as the
steam ironing temperature has
been reached (
● ● ●
).
electron
ic
Filling with water
2
Slowly remove the protective
label/cover from the soleplate.
Holding the iron vertical, pour
water into the water filling inlet, up
to the "max." mark on the water
tank. Plug the iron into the outlet.
1
(Depending on model.) If the iron
is not moved while it is plugged in,
an internal safety switch will turn it off.
It will turn off in 8 minutes if left verti-
cally or in 30 seconds if left on its sole-
plate or tipped over. A red flashing light
indicates that the auto-off has been
activated. To switch the iron on again,
move the iron or gently shake it.
30 sec.
30 sec.
8 min.
e
le
c
tr
o
n
ic
electron
ic
Vertical steaming
9
(Depending on model.)
Check packaging.
This is especially useful for getting
wrinkles out of hanging clothes,
curtains etc.
Warning! Never iron clothes on
the body or point your iron at
anybody when steaming!
e
le
c
tr
o
n
ic
E
H
I
K
J
A
B
F G
L
D
C
electron
ic
3-way
Auto-off
Auto off is not
an on/off switch.
Unplug the iron
when it is not in
use.