Make a permanent record of the model and serial number of your new air compressor here. You’ll save time and
expense by including this reference information when requesting service or replacement parts.
INSTALLATION ~ OPERATION ~ MAINTENANCE
RECEIVING INSTRUCTIONS
CONGRATULATIONS ON THE PURCHASE OF YOUR NEW ROLAIR COMPRESSOR!
Immediately upon receipt of your air compressor and prior to completely uncrating, the following steps should be taken:
Step 1) Remove box and inspect compressor for damage that may have occurred during shipment. If any damage is
found, demand an inspection from the carrier. Ask the carrier how to file a claim for shipping damages. Freight
damage is not covered by ROLAIR warranty.
Step 2) Insure that adequate lifting equipment is available for moving the air compressor.
Step 3) Record the model number and serial number from the unit nameplate on the front of your owner’s manual. Space
is also provided for pump-up time test to be performed and recorded upon initial start-up of air compressor.
Place & Date of Purchase
Volts
Model
Hz
Serial #
HP
From 0 to _____PSI
From 0 to _____PSI
Date Min. Sec. Date Min. Sec.
RECORD OF PERTINENT INFORMATION
STATIONARY
AIR COMPRESSOR
MANUAL
WARNING
COMPRESSOR DISCHARGE AIR MAY CONTAIN HYDROCARBON
AND OTHER CONTAMINANTS; THEREFORE, DO NOT USE
DISCHARGE AIR FOR BREATHING.
With shut-off valve to outside line(s) closed and tank pressure at 0 PSI, record the amount of time it takes to build tank
pressure in the space provided below. Periodically test your compressor against this pump-up time to determine if it is
operating correctly. If time test is considerably off, contact your local ROLAIR representative to arrange service.
606 South Lake Street > P.O. Box 346 > Hustisford, WI 53034-0346 > 920.349.3281 > fax 920.349.3691 > www.rolair.com
