1
2
riva Systemtechnik GmbH | Brunnenstr. 29 | D-78554 Aldingen
Tel.: +49 7424 90140-18 | Fax: +49 7424 90140-62 [email protected] | riva-filter.de MADE IN GERMANY - BLACK FORREST
INSTALLATION GUIDE – riva DRINK WATER FILTER
Installation of a riva VARIO filter housing with integrated filter cartridge
under the sink or the kitchen sink.
riva-filter.de
Technical specifications
Dimensions:
Ø 67 x120 mm
Housing material:
Al-Mg-Si-1 anodized
Filter typ:
As you ordered
Connection:
Inlet G1/2 internal thread, outlet G1/2 external thread
Flow rate:
5 – 7 Liter per minute at 2 – 3 bar water pressure
General instructions
The delivery includes the selected filter cartridge. The cartridge is already pre-installed in the filter housing. All installation work should be
carried out and checked by experts. riva is not liable for faulty installation.
Make sure that the water in and outlet are installed correctly. The arrow on the body and cartridge indicates the direction of flow which
must be observed.
In the event of improper installation, no liability is assumed for any damage arising. Protect from frost. The filter cartridge should be chan-
ged after 6 months (DIN 1988). However, an earlier change may be necessary if the water flow is noticeably/ visibly reduced. A previously
necessary change is not a defect in the cartridge used, but an indication of an increased occurrence of fine particles in the unfiltered water.
For use in conjunction with a hot water boiler or instantaneous water heater, please contact your system specialist. When installed under the
sink, the filter must be professionally connected directly to the angle valve of the cold water pipe. In exceptional cases, condensation water
may form in the filter housing of very cold water in the supply line for physical reasons. An installation always requires the installation of a
certified check valve / inlet stop or a water stop system, e.g. Aquastop.
IMPORTANT NOTES BEFORE YOU BEGIN
•
You need a riva VARIO filter housing, a riva filter cartridge and a riva
hose connection set with adapters.
•
Before starting the assembly, close the water supply line at the
corresponding water pipe.
•
Remove the filter housing from the packaging. The filter cartridge is
already inserted in the housing.
•
Required tool: fork wrench 24 (fork width 24 mm) or a pipe wrench.
•
Close the cold water connection and loosen the
connection to the fitting with the Gabess spanner
or the pipe wrench.
•
Mount the flexible hoses from the riva hose set to the
riva VARIO filter housing with the connection adapters
(suitable for your system).
•
Tighten all connections very tightly with the pipe
wrench or the open-end wrench.
Connection filter system
