1
*
Programming Quick Guide
-LS6307L/ LS6327L.
Installation
Make sure that the scanner has the correct cable to plug in the PC as below
described: *Note : Please install PL-2303 driver for USB serial
Auto-sensing setup
(For LS6327L Only)
The auto-sensing will active
while scanner position on stand.
When scanner remove from
stand will become trigger mode.
Reset Configuration to Defaults
If you are unsure of the scanner configuration or have scanned the
incorrect codes, please scan from A1 to A3 for USB HID or B1 to B5 for
RS232 or USB Serial. This will reset the scanner to its factory defaults.
A1
B1
A2
B2
A3
B3
B4
B5
Barcode Configuration Method:
(Flow chart for setup procedure :)
Start
Configuration
End
Configuration
Keyboard Country (For USB HID only)
Scan the appropriate country code as below to program the keyboard
layout for your country or language. As a general rule, the following
characters are supported, but need special care for countries other
than the United States
: @ | $ # { } [ ] = / ‘ \ < > ~
USA
Japan
Denmark
Finland
France
UK
Italy
Norway
Turkey F
Turkey Q
Keyboard Country (For USB HID only)
Scan the appropriate country code as below to program the keyboard
layout for your country or language. As a general rule, the following
characters are supported, but need special care for countries other
than the United States
: @ | $ # { } [ ] = / ‘ \ < > ~
Belgium
Spain
Germany
Austria
Russia
Sweden
Portugal
1D Symbologies – 1
ENABLE
EAN-8
DISABLE
ENABLE
EAN-13
DISABLE
ENABLE
ISSN
DISABLE
ENABLE
ISBN
DISABLE
ENABLE
Codabar
DISABLE
