1
Programming Quick Guide
L S 6 3 0 3 X / L S 6 3 2 3 X .
Getting Started
Power up the computer once the scanner is fully connected.
Connecting the Scanner
USB Connection : USB(HID)
Auto-sensing setup
(For LS6323X Only)
The auto-sensing will active
while scanner position on stand.
When scanner remove from
stand will become trigger mode.
Barcode Scanner Reading Techniques
The view finder projects an
aiming beam that should be
centered over the bar code, but it
can be positioned in any direction
for a good read.
Hold the scanner over the bar code, pull the trigger, and center the
aiming beam on the bar code.
The aiming beam is smaller when the scanner is closer to the code
and larger when it is farther from the code. Hold the scanner close to
smaller bar codes, and farther away from large bar codes to get a
proper read.
If the bar code is highly reflective (e.g., laminated), you may need to
tilt the scanner at an angle so the bar code can be scanned.
Standard Product Defaults
The following bar code resets all standard product default settings.
Standard Product Defaults
Trigger
The following bar codes will allow you to use the scanner in Manual Trigger -
Normal Mode (need to press the trigger to read) or Presentation mode (the
scanner is activated when it “sees” a bar code).
Manual Trigger–Normal
(Default)
Presentation Mode
Streaming Presentation™
When in Streaming Presentation mode, the scanner leaves the scan illumination
on all the time and continuously searches for bar codes.
Streaming Presentation Mode
Keyboard Country
(For USB HID Only)
Scan the appropriate country code as below to program the keyboard layout for
your country or language. As a general rule, the following characters are
supported, but need special care for countries other than the United States
: @
| $ # { } [ ] = / ‘ \ < > ~
Belgium
Demark
Finland
France
Germany/
Austria
Great Britain
Italy
Norway
Spain
Switzerland
USA(Default)
Suffix
If you want a carriage return after the bar code, scan the Add CR Suffix bar
code. To add a tab after the bar code, scan the Add Tab Suffix bar code.
Otherwise, scan the Remove Suffix bar code to remove the suffixes
Add CR Suffix
Add Tab Suffix
Remove Suffix
1D Symbologies -1
ENABLE
Codabar
DISABLE
ENABLE
Code 39
DISABLE
ENABLE
Code 39
Full ASCII
DISABLE
ENABLE
Code 32
DISABLE
ENABLE
Interleaved
2 of 5
DISABLE
ENABLE
NEC 2 of 5
DISABLE
ENABLE
Code 93
DISABLE
ENABLE
Straight 2 of 5
Industrial
DISABLE
ENABLE
Straight 2 of 5
IATA
DISABLE
