RIOTEC iDC92700, Quick Manual

Page: 1 / 6

1
Quick Guide
- iDC92700
1
Connect to micro USB port of
Smartphone
2
3
*
Before you use scanner, please switch to "C- Charge
mode" and charge inside battery for 3~4 hours first.
*
Under “C- Charge mode”, you can raise/lower soft-
keyboard easily.
(For HID profile only)
4
*
iDC92700 is with Li-Ion battery inside. When in
charging, please use the original USB power adaptor
of Smartphone (recommended). Through it, it charges
both smartphone & iDC92700 batteries at the same
time.
*
When in low battery (Orange LED flashing), please
charge it immediately.
*
In case the power consumed out totally; the RTC (Real
Time Clock) will back to original setting 01012000.
Attention: Please don’t charge iDC92700 when in Operation
mode. Otherwise, the smartphone’s battery will charge back
to iDC92700’s battery.
5
** When pressing Left Right button for 8~9
seconds, iDC92700 will enter deep sleeping mode.
** Please press Left Right Touch trigger
for 8~9 seconds to activate iDC92700 .
** The touch sensor area is around the central area.
Please check the above drawing for your reference.
LED Indicator Information
Orange LED ON Full charged
Orange and Red LED Flashing Charging
Orange LED Flashing Low battery
Red LED ON Off line / out of service
Green LED ON Good read
Orange LED ON Good read (Batch mode)
O=Operation mode
C=Charge mode
Left Button
Under BT HID Profile, press Left button to
raise/lower soft-Keyboard; press the left button for 4
seconds to un-pair. Then, scanner can be connected
with other BT devices (Please check page #2, left
column)
Touch Trigger Area
SCAN/ Power ON
Press 1 second to wake it
up from power saving
mode
Right Button
Power Saving button:
Press the button for 4 second
then enter power saving mode
Indicator
(LED)
Charge port
Suction Cup
PU Glue
(Can be used
repeatedly)
Micro USB
cable (OTG)
Exit Window
Li- Ion Battery inside
Indicator (LED)