INFINITY pipe cover
Installation guide
Rinnai New Zealand Ltd (0800 746 624)
INF pipe cover installation 9509-F
I
06-20
1 of 2
Before installation check for damage, do not install any damaged items, and check all components
have been supplied. Read these instructions to get an overview of the steps required before
starting.
With Rinnai’s current range of water heaters, assembly can be done by the homeowner—this is
because assembly does not require taking the cover off the water heater.
The pipe cover is approximately the same width and depth of the water heater and conceals
approximately 450 mm of pipework below the unit.
Pipe cover
Suitable for
R1385
Rinnai INF A16-A26
Rinnai INF VT16-VT26*
R1402SC
Rinnai INF HD250
R1408
Rinnai INF EF24
R1408SC
Rinnai INF HD200 / HDi200
R1416
Rinnai INF EF26
* Discontinued models
Top frame
Side panel RH
Side panel LH
Bottom bracket
Rear bracket
Front panel
Screw M4 x 8
SS (x8)
Nylon washer M4
(x10)
Screw M4 INF
pipe cover (x2)
PK screw #8 x 6
SS (x 2)
PK screw #10 x 40
ZP (x 2)
Important
Before installing the pipe cover turn off the power, water, and gas to the water heater.
Assembly
1. Assemble the top frame to the right and
left side panels with four M4 screws and
washers.
2. Secure the bottom bracket to the left
and right panels with two M4 screws and
washers.
3. Secure the rear bracket to the left and right
panels with two M4 screws and washers.
IMPORTANT
Side panel LH
Side panel RH
Top frame
Rear bracket
Bottom bracket
