Tilt Flat Panel Bracket
Installation instruction
Warning Statements
Prior to the installation of this product, the installation
instructions
should be read and
completely
understood. The installation instructions
must be read to prevent personal
injury
and property
damage. Keep these instructions
in an
easily accessible location for
future
reference.
Recommended mounting surfaces: wooden studs and
brick.If the mount is to be
installed on
any surface other than wooden studs,use suitable hardware
(which is commercially available).
Do not install on a structure that is prone to vibration, movement or
chance of impact.
Failure
to do so could result in damage to the display
and/or damage to the mounting surface.
Don
'
t install near heater, fireplace, direct sunlight
,
air conditioning
or any other
source of
direct
heat energy. Failure to do so may result
in damage to the display
and could increase the risk of
fire.
The
maximum
loading
weight
is
30 kg
.
Use of
heavier screen
than
the specified
A secure structure must support the weight or load of the display
,
When
mounting
to
a
wall
that
contains
wooden
studs
,
dead
center
of
the
wooden
stud
must
be
confirmed
prior
to
installation
.
At least two qualified people should perform the installation procedure.Injury and/or
damage
can result from dropping or mishandling the display.
IMPORTANT:If you don't understand the right installation procedure,
please consult with an installation specialist
Step1: Wall plate installation
Wood Stud Installation
NOTE
least
16"apart.
:For secure wood stud mounting,the wall plate must be mounted
to two studs at
Use a high-quality electronic stud finder (commercially available) to locate two adjacent studs
and mark their locations with a pencil.
1
Mark the right (upper and lower) and the left (upper and lower) positions of the small horizontal slots that are in
alignment with the studs.
2
3
1
With the help of an assistant, and using the bubble level to ensure the wall plate is at level, position the wall
plate against the wall in the desired mounting location.
4
Mark four positions total.
5
Pre-drill a 5mm hole 50mm depth in the wall stud at each marked location.
6
please position the wall plate against the wall and line up the mounting slots with drilled holes
7
For each location, insert a lag bolt and washer into the wall
8
Tighten bolt with an open ended socket wrench by turning clockwise until tight.
weight might result in injury and/or damage.
Fixed Wall Mount
TV Size:14"-37"
Max load capacity:25kgs/55lbs
wall distance:23.5mm
Bubble level system included
Universal Mounting Pattern
VESA: 200X200 mm
Hardware kit:
A
B
C
(×4) M5×16 screw
(×4) M6×16 screw
(×4) M8×16 screw
D
E
F
G
(×4) M8/M6/M5 Washer
(×6) M8 Bolt
(×6) M8 concrete anchor
(×6) M8 Washer
