RE322 DSC Compatible NanoMax Instructions - May 15, 2015
24-Hour Tech Support Line: (715)808-0164
www.ResolutionProducts.com
RE322 DSC
®
-Compatible NanoMax
™
Door/Window
Programming/Enrolling
Place control panel in enrollment mode
Remove the battery tab to send RF enrollment signal
Installation
•
The 3M VHB™ tape is an extremely effective adhesive. However it requires three things to
properly bond:
1.
Clean surface – any standard cleaner will work, but surface must be dry afterwards.
2.
Warm temperature – if temperature is below 50F, warm the mounting surface by
vigorously rubbing it with something clean.
3.
Pressure – apply firm pressure for 10-15 seconds.
•
Remove 3M VHB™ tape backing
•
Place on desired location of door or window
•
External Contact: Internal magnetic switch
cannot
be used when external contact is
installed. See next page for external contact mounting.
Operation
•
Alarm when…
o
Magnet is pulled away from internal reed switch, or
o
External contact is opened
•
Tamper Alarm, when cover is opened
•
Supervisory transmission, every hour
•
Low battery indication, when battery is nearing end of life
Physical
Housing dimensions
1.8 x 0.77 x 0.39 inches
Weight with battery
0.529 ounces
Mounting fastener
3M VHB™ Tape
Tamper activation
Cover removal
Environmental
Operating temperature
32°F to 120°F
Specifications
Magnet trip distance
1 inch nominal
Replacement battery
Panasonic CR1632
Battery life
6 years
Strong, reliable RF signal
Maximum FCC power
Battery tab can be extracted
without removing the cover
RF Enrollment signal is
sent after tab is removed
RE322 DSC Compatible NanoMax Instructions - May 15, 2015
24-Hour Tech Support Line: (715)808-0164
www.ResolutionProducts.com
RE322 DSC
®
-Compatible NanoMax
™
Door/Window
Programming/Enrolling
Place control panel in enrollment mode
Remove the battery tab to send RF enrollment signal
Installation
•
The 3M VHB™ tape is an extremely effective adhesive. However it requires three things to
properly bond:
1.
Clean surface – any standard cleaner will work, but surface must be dry afterwards.
2.
Warm temperature – if temperature is below 50F, warm the mounting surface by
vigorously rubbing it with something clean.
3.
Pressure – apply firm pressure for 10-15 seconds.
•
Remove 3M VHB™ tape backing
•
Place on desired location of door or window
•
External Contact: Internal magnetic switch
cannot
be used when external contact is
installed. See next page for external contact mounting.
Operation
•
Alarm when…
o
Magnet is pulled away from internal reed switch, or
o
External contact is opened
•
Tamper Alarm, when cover is opened
•
Supervisory transmission, every hour
•
Low battery indication, when battery is nearing end of life
Physical
Housing dimensions
1.8 x 0.77 x 0.39 inches
Weight with battery
0.529 ounces
Mounting fastener
3M VHB™ Tape
Tamper activation
Cover removal
Environmental
Operating temperature
32°F to 120°F
Specifications
Magnet trip distance
1 inch nominal
Replacement battery
Panasonic CR1632
Battery life
6 years
Strong, reliable RF signal
Maximum FCC power
Battery tab can be extracted
without removing the cover
RF Enrollment signal is
sent after tab is removed
