STEP 5 - THE FINISHING TOUCHES
a.
Use the hair clipper without an attachment comb for close trimming around
the base and sides of the neck.
b.
To produce a clean straight line at the sideburns, reverse the clipper. Place
the reversed hair clipper at right angles to the head, tips of the blades lightly
touching the skin and then work downwards.
CLEANING & MAINTENANCE
Cleaning & Maintaining Your Hair Clipper
After each use:
•
Brush the accumulated hair from the cutters. Do not submerge the hair
clipper in water.
Click N’ Wash System
•
The Click N’ Wash system is designed to maximise the efficiency of
washable cleaning.
•
Click the Click N’ Wash buttons that are located on the sides of the hair
clipper head. The blades will slide out allowing the blade to be easily be
cleaned under the tap.
•
Once the blades are cleaned, lock them back into place by pushing the
blade set towards the clipper body. You will hear a “click” when blades are
locked into place.
•
Do not run the entire unit under the tap, only the blade set is meant to be
rinsed in water.
•
Add oil, place a few drops of cutter or sewing machine oil onto the blades
after rinsing with water.
Note:
Ensure that the hair clipper is turned off when cleaning.
Every six months:
At regular intervals the blade set should be removed and cleaned. To remove
the blade set, remove the two screws holding the large blade to the hair
clipper body. The blade set will separate from the body and can be cleaned as
necessary. Brush out hairs from between blades with the cleaning brush. Place
a few drops of cutter or sewing machine oil onto the blades. Wipe off excess
oil.
11
8
9
10
12
Spectrum Brands Australia Pty Ltd and Spectrum Brands New Zealand Limited
W
REMINGTON SERVICE HOTLINE
Australia 1800 623 118 (toll free)
New Zealand 0800 736 776 (toll free)
AUTHORISED REPAIR CENTRES
Visit www.remington-products.com.au for Authorised repair centre details.
® Registered Trade Mark of Spectrum Brands Inc., or one of its subsidiaries
© 2012 SBI
Rev. 05/12
Part No. T22-0000429
2 YEAR
WARRANTY
HC5355AU
USE & CARE
MANUAL
PLEASE READ
PRIOR TO USE
This product is not suitable to use in a bath or shower.
This product conforms to radio frequency interference requirements.
Any product purchased and used commercially carries a limited 90 Day Warranty.
ArrANTY AGAINST dEFECTS
In this warranty:
Australian Consumer Law
means the Australian consumer law set out in Schedule 2
to the Competition and Consumer Act 2010;
CGA
means the New Zealand Consumer Guarantees Act 1993;
Goods
means the product or equipment which was accompanied by this warranty and
purchased in Australia or New Zealand, as the case may be;
Manufacturer, We
or
us
means:
1. for Goods purchased in Australia, Spectrum Brands Australia Pty Ltd
ACN, 007 070 573; or
2. for Goods purchased in New Zealand, Spectrum Brands New Zealand Limited,
as the case may be, contact details as set out at the end of this warranty;
Supplier
means the authorised distributor or retailer of the Goods that sold you the Goods
in Australia or in New Zealand; and
You
means you, the original end-user purchaser of the Goods.
1. Our goods come with guarantees that cannot be excluded under the Australian
Consumer Law, or the CGA. You are entitled to a replacement or refund for a major failure
and compensation for any other reasonably foreseeable loss or damage. You are also
entitled to have the goods repaired or replaced if the goods fail to be of acceptable
quality and the failure does not amount to a major failure.
2. The benefits provided by this Warranty are in addition to all other rights and remedies in
respect of the Goods which the consumer has under either the Australian Consumer Law
or the CGA. The original purchaser of the Goods is provided with the following Warranty
subject to the Warranty Conditions:
3. We warrant the Goods for all parts defective in workmanship or materials for the period
of two (2) years from the date of purchase
(Warranty Period)
. If the Goods prove
defective within the Warranty Period by reason of improper workmanship or material,
we may, at our own discretion, repair or replace the Goods without charge.
Warranty Conditions
4. The Goods must be used in accordance with the manufacturer’s instructions. This
Warranty does not apply should the defect in or failure of the Goods be attributable to
misuse, abuse, accident or non-observance of manufacturer’s instructions on the part of
the user. As far as the law permits, the manufacturer does not accept liability for any
direct or consequential loss, damage or other expense caused by or arising out of any
failure to use the Goods in accordance with the manufacturer’s instructions.
5. Exhaustible components (such as shaver heads, cutters and foils) of the Goods
are included under this Warranty only where there is a defect in workmanship or
materials used.
6. The warranty granted under clause 3 is limited to repair or replacement only.
7. Any parts of the Goods replaced during repairs or any product replaced remain the
property of the manufacturer. In the event of the Goods being replaced during the
Warranty Period, the warranty on the replacement Goods will expire on the same date
as for the Warranty Period on the original Goods which are replaced.
8. In order to claim under the warranty granted under clause 3 you must:
(a) Retain this warranty with your receipt/proof of purchase; and
(b) Return the Goods to us at the relevant address below or to the Supplier by prepaid
freight within the Warranty Period accompanied with (i) the legible and unmodified
original proof of purchase, which clearly indicates the name and address of the
Supplier, the date and place of purchase, the product name or other product serial
number and (ii) this warranty.
9. This warranty is immediately void if:
(a) Any serial number or appliance plate is removed or defaced;
(b) The Goods have been serviced or otherwise repaired by a person not authorised to
do so by us or where non approved replaced parts are used.
10. The Goods are designed for domestic use only. A limited 90-day Warranty applies to any
industrial or commercial use of the Goods. The Goods must be connected to the electrical
voltage requirements as specified in the ratings label located on the Goods.
11. This warranty does not cover the cost of claiming under the warranty or transport of the
Goods to and from the Supplier or us.
12. This warranty is only valid and enforceable in Australia against Spectrum Brands
Australia Pty Ltd and in New Zealand against Spectrum Brands New Zealand Limited.
Contact us or the Supplier for further details.
Spectrum Brands Australia Pty Ltd
Chifley Business Park
1 Chifley Drive
Mentone, VIC 3194 Australia
Customer service in Australia: 1800 623 118
E-mail: [email protected]
Website: www.remington-products.com.au
Spectrum Brands New Zealand Limited
Building C, Ground Floor
600 Great South Road,
Greenlane, Auckland 1051 New Zealand
Customer service in New Zealand: 0800 736 776
E-mail: [email protected]
Website: www.remington-products.com.au
Cleaning Cautions:
Do not use liquid cleaners on the cutters or harsh or corrosive chemicals on the
cutter casing.
Unplug the charge adaptor from the power outlet when not in use and when
cleaning.
Storage
Always store this appliance and cord in a moisture-free area.
Do not wrap the cord of the charging adaptor around the appliance.
Do not store in temperatures above 60ºC.
TrOUBLESHOOTING
The hair clipper does not work when turned on:
The hair clipper must be charged for a full 14-16 hours, or use clipper while
plugged into wall.
Hair clipper cutters do not move:
The cutting unit may be dirty and clogged. Clean the unit as directed in
Cleaning & Maintaining section.
Hair Clipper does not hold charge:
Fully discharge battery by running hair clipper until it stops; then follow
recharging instructions (see section on Charging Your Hair Clipper).
PRO PACk
CLIPPER
