background image

REDNECK 6x7 SUPPORT ARM ASSEMBLY INSTRUCTIONS

READ THESE INSTRUCTIONS IN THEIR ENTIRETY PRIOR TO ASSEMBLING THIS PRODUCT 

WARNING! Do not remove, modify and/or omit any portion or otherwise 

mechanically modify this product(s) or its assemblies in any manner. 

Modification, misuse and/or part substitution shall immediately void 

your factory warranty. If you suspect that a part(s) is missing and/or 

defective, immediately discontinue all use of the product and contact 

Redneck Outdoor Products at 877-523-9986 for replacement of missing 

or defective parts.   
NOTE: Some parts of this product are manufactured to be universal in 

use, so there may be some parts containing holes that will not be used 

in the assembly of this particular model. To minimize confusion in the 

assembly process, please read these instructions in their entirety 

before beginning.  
Should you have any questions about the assembly, installation or use 

of this product, or any other Redneck Outdoor Products, please call one 

of our customer service representatives toll free at 877-523-9986.  

RD-STD67BR

-1-

Summary of Contents for RD-STD67BR

Page 1: ...l use of the product and contact Redneck Outdoor Products at 877 523 9986 for replacement of missing or defective parts NOTE Some parts of this product are manufactured to be universal in use so there may be some parts containing holes that will not be used in the assembly of this particular model To minimize confusion in the assembly process please read these instructions in their entirety before...

Page 2: ...ER 2 C SUPPORT TUBE 2 B MOUNTING BRACKET 2 A MOUNTING BRACKET 2 BILL OF MATERIALS HARDWARE 3 8 16 BOLT 1 25 LONG 6 3 8 16 NUT 4 3 8 FLAT WASHER 8 3 8 LOCK WASHER 8 3 8 16 BOLT 3 25 LONG 2 THERE WILL BE LEFT OVER HARDWARE 2 ...

Page 3: ...Make sure you only tighten the bolts finger tight while installing Next take the Mounting Brackets A B out of the 6x7 Arm Kit and attach it to the outside of the legs as shown in Figure 10 2 10 3 Fasten these to the stand using the standard hardware out of the stand box Make sure that both brackets are facing in towards the middle of the platform see figure 10 3 Repeat this step for the other side...

Page 4: ...h the tabs in each bracket as shown in figure11 2 Make sure to start the bolts with your fingers so you dont strip out the rivet nuts inside the tubes Once you have them finger tight fully tighten with a wrench STEP 4 Once all the arms are in place and secure you can finish building the rest of the stand Make sure that all bolts are tightened and secured correctly Once the blind is bolted to the p...

Reviews: