background image

1

!

COUNT INPUT FROM 10 to 300 VAC/DC 

!

LCD, POSITIVE IMAGE REFLECTIVE OR NEGATIVE IMAGE
TRANSMISSIVE WITH YELLOW/GREEN OR RED LED
BACKLIGHTING (9 to 28 VDC power supply required for versions
with LED backlighting)

!

0.35" (8.90 mm) HIGH DIGITS

!

REPLACEABLE INTERNAL LITHIUM BATTERY PROVIDES UP TO
7 YEARS OF UNINTERRUPTED OPERATION

!

NEMA 4X/IP65 SEALED FRONT BEZEL

!

FRONT PANEL RESET OR REMOTE RESET

!

WIRE CONNECTION MADE VIA SCREW CLAMP TYPE
TERMINALS

!

FITS DIN STANDARD CUT-OUT 1.77" (45 mm) x 0.874" (22.2 mm)

DESCRIPTION

The CUB7W is an 8-digit miniature counter with large 0.35 inch (8.90 mm)

high digits. It has an LCD read-out available in Positive Image Reflective
(CUB7W000), Negative Image Transmissive with yellow/green backlighting
(CUB7W010) or red backlighting (CUB7W020)

The backlight versions

require an external 9 to 28 VDC power supply.

The CUB7W accepts most machine control voltage signals. The input

accepts AC (50/60 Hz) or DC control voltages from 10 to 300 V at count speeds
up to 30 counts per second (cps).

The CUB7W counters use a CMOS LSI counter circuit chip, mounted on a

gold-plated substrate, that is electrically connected by ultrasonic wire-bonding.
Proven micro-electronic assembly and manufacturing techniques provide these
units with the reliability and dependability required for industrial service.

The CUB7W series is housed in a lightweight, high impact plastic case with

a clear viewing window. The sealed front panel with the silicone rubber reset
button meets NEMA 4X/IP65 specifications for wash-down and/or dusty
environments, when properly installed.

SAFETY SUMMARY

All safety related regulations, local codes and instructions that appear in the

manual or on equipment must be observed to ensure personal safety and to
prevent damage to either the instrument or equipment connected to it. If
equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.

SPECIFICATIONS

1. 

DISPLAY:

8-digit LCD, 0.35" (8.90 mm) high digits.

2. 

POWER SOURCE:

Replaceable Internal 3.0 V lithium battery to provide

up to 7 years of continuous operation. (Battery life is dependent upon usage.
Reset contacts that remain closed for long periods of time reduce battery life.)

3. 

BACKLIGHT POWER REQUIREMENTS: 

9 to 28 VDC; 35 mA. typical,

50 mA max. Above 26 VDC, derate max. operating temperature to 40°C. 

4. 

L. S. INPUT:

10 to 300 VAC/DC, 50/60 Hz, 30 cps max. 150 V max. for

backlight versions. V

IL

= 0.5 VDC max. Unit counts on the positive going

edge.

Note: For triac inputs, use the standard CUB7 with a TCM module.

5. 

REMOTE RESET:

15 msec min. pulse width (active low) from 3.0 V

bipolar output, an open collector transistor, or a switch contact to common.
V

IH

= 2.0 V min. (3 V max), V

IL

= 0.5 V max.

6. 

ENVIRONMENTAL CONDITIONS

:

Operating Temperature Range

: 0 to 50°C. Derate max. operating

temperature to 40°C above 26 VDC (Backlight versions).

Storage Temperature

: -30 to 80°C

Operating and Storage Humidity

: 85% max.relative humidity (non-

condensing) from 0°C to 50°C.

Altitude

: Up to 2000 meters

MODEL CUB7W - MINIATURE ELECTRONIC 8 DIGIT COUNTER w/VOLTAGE INPUT

DIMENSIONS   In inches (mm)

Note: Recommended minimum clearance (behind the panel) for mounting

clip installation is 2.15" (54.6) H x 3.00" (76.2) W.

CAUTION: Read complete

instructions prior to installation

and operation of the unit.

CAUTION: Risk of electric shock.

Bulletin No.  CUB7W-G
Drawing No.  LP0384
Released  10/01

Tel +1 (717) 767-6511
Fax +1 (717) 764-0839
www.redlion-controls.com

PANEL CUT-OUT

Summary of Contents for CUB7W Series

Page 1: ...s and instructions that appear in the manual or on equipment must be observed to ensure personal safety and to prevent damage to either the instrument or equipment connected to it If equipment is used in a manner not specified by the manufacturer the protection provided by the equipment may be impaired SPECIFICATIONS 1 DISPLAY 8 digit LCD 0 35 8 90 mm high digits 2 POWER SOURCE Replaceable Interna...

Page 2: ... meets NEMA 4X IP65 requirements for indoor use when properly installed Installation Category I Pollution Degree 2 Panel gasket and mounting clip included 9 WEIGHT 2 oz 57 grams with battery ENVELOPE PACKAGING APPLICATION A customer has 18 envelope packaging machines to be upgraded These machines have existing preset counters for batching purposes The customer now wants to add totalizing capabilit...

Page 3: ...cessive heat should be avoided The bezel should be cleaned only with a soft cloth and neutral soap product Do NOT use solvents Continuous exposure to direct sunlight may accelerate the aging process of the bezel Do not use tools of any kind screwdrivers pens pencils etc to operate the keypad of the unit Installation The CUB7W meets NEMA 4X IP65 requirements for indoor use when properly installed T...

Page 4: ...ontrol relays transformers and other noisy components 4 In extremely high EMI environments the use of external EMI suppression devices such as ferrite suppression cores is effective Install them on Signal and Control cables as close to the unit as possible Loop the cable through the core several times or use multiple cores on each cable for additional protection Install line filters on the power i...

Reviews: