OPENER
WALL
PUSH
BUTTON
TRANS
PRIMARY
24v
1
2
3
Universal Radio
Control (Top)
Common
Push Button
Radio Pwr.
#3 Connection
(optional)
TM
This unit is specifically designed to operate with Raynor
residential garage door openers. Use on other types may
result in damage to the receiver.
NOTE: Models 540-1RGD and 540-2RGD are factory
pre-set with matching receiver and remote control
codes. If you purchase additional remote controls,
the receiver may be programmed to match the new
remote control code (up to 4 “smart” remotes and
one Keyless Entry Transmitter).
THE RECEIVER MAY BE INSTALLED IN ONE OF TWO
WAYS:
1. Mounted directly on the door opener with clips
provided as shown on page one.
2. Attached to an inside wall of the garage with connecting
bell wire (not supplied) as shown on side two.
When installing two or more receivers in a garage,
position them at least 10 feet apart to prevent electronic
interference.
MOUNTING ON RESIDENTIAL OPENERS
Use a 3 wire connection only. Attach mounting clips to
receiver terminals 1, 2, and 3, and to the opener
terminals used for push button controls (Figure 1).
MOUNTING ON GARAGE WALL
Fully extend the antenna wire below bottom of case.
Fasten the receiver to an inside garage wall with dry wall
screws provided. A convenient place is alongside the
service door and
OUT OF THE REACH OF CHILDREN.
Attach one end of 3-strand bell wire (not supplied) to
receiver terminals 1, 2 and 3. Connect the other end to
the three opener terminals used for push button controls
and radio power (Figure 2). Use insulated staples to
secure bell wire between receiver and opener.
Reconnect power to the opener. The receiver push bar
should light.
Model 540RGD
Receiver Only
Model 540-1RGD
(With 1 Remote Control)
Model 540-2RGD
(With 2 Remote Controls)
Side two contains code setting instructions and
service information.
Children operating or playing with a garage door
opener can injure themselves and others.
The
garage door could close and cause serious injury
or death. Do not allow children to operate the
push buttons or the remote control transmitters.
Install the receiver (and any additional push
buttons) out of the reach of children and away
from all moving parts of the door and door
hardware, but
where the garage door is visible.
A moving garage door could injure someone
under it. Activate the opener only when the door
is properly adjusted, you can see it clearly, and
there are no obstructions to door travel.
WARNING
Disconnect power to the garage door opener
before installing the receiver.
G
WARNING
OPENER
TERMINALS
Receiver
Terminals
Antenna Wire Fully Extended
Flange
Mounting
Clip #1
Mounting
Clip #2
Mounting
Clip #3
Common
Push Button
Radio Power
To comply with FCC/IC rules, adjustment or modification of receiver and/or
transmitter is prohibited, except for changing the code setting and replacing
the transmitter battery. THERE ARE NO USER SERVICEABLE PARTS.
NOTICE TO U. S. CONSUMERS:
Some states prohibit the service or repair of garage door
openers whch cannot be made to comply with the safety
standards contained in UL 325 (1988 revision). In order to
comply with both the letter and the spirit of these laws, this
universal radio control should not be used with any Raynor, Lift-
Master
®
, Chamberlain
®
, or Sears Craftsman
®
garage door opener
manufactured prior to April 1, 1982. To find out if your
Chamberlain-made garage door opener was manufactured prior
to or after April 1, 1982, please call 1-800-528-9131 before
installing this universal radio control.
Figure 1
Mounting on
Opener
Figure 2
Mounting on Wall
1
GARAGE DOORS
Universal Radio Control
OWNERS MANUAL
