Copyright © 2013 RapID Lab, Inc. All rights reserved.
Setting up CODE CR1500 Scanner for RapID Tags as a USB keyboard
The instructions below will program the CODE CR1500 Scanner to properly decode the
RapID Tag Data matrix symbols. More information may be found on the RapID Lab
website:
http://rapidlab.com/scanner-and-software-support/
1.
Unplug the CODE CR1500 from the PC.
2.
While holding the trigger pressed, plug the reader into the USB port on the PC and
hold for 5-10 seconds. You will hear 5 rapid beeps and then you can let go of the
trigger. The unit is now in Boot Mode.
3.
To reset the CODE CR1500, simply hold the trigger down again for approximately 5-
10 seconds until it reboots. The reader will vibrate first and then beep several times
and is now reset.
4.
Next, simply scan the following codes shown in the table below.
Required Codes:
Remove previous programming Custom settings requiring
suffix <Enter>
Additional optional codes on the page below.
