www.rammy.fi
MAINTENANCE
Object of maintenance
Operation
Type
Service
interval
Lubricate the end bearings of
the auger. There are grease
fittings on the side of the
bearings. Protect the fittings
with a plug.
Check the tension of the set
screws of the bearings. Apply
glue if needed.
Tighten the fastening screws.
Check the screw connections
between the engine,
transmission and other parts.
Bearing
vaseline,
operating
temperature -
30…+60
degrees
Thread-locking
glue
20 hours (about
10 tanks of
gasoline) or once
per season.
2 hours after first
use and every 20
hours thereafter
or once per
season
Check the condition of the
belts. Replace a worn belt by
removing the larger pulley.
Loosen the two hex screws and
set one screw into a blank
thread. Tighten the screw to
release the lock. Install a new
belt and slide the pulley back
into the axel. Tighten the hex
nuts, in turns evenly, back into
the original places.
Check condition and fastening
of springs.
The tension of the screws on
the engine belts is 6 Nm. The
tension on the pulleys of the
auger is 32 Nm.
Check the tension of protection
pins (5 pcs) of the belt. Adjust
the clearance of the pin and
belt to 1…3 mm.
