ALL ELECTRICAL CONNECTIONS MUST CONFORM TO NATIONAL AND LOCAL ELECTRICAL
CODES AND STANDARDS. A QUALIFIED, LICENSED ELECTRICIAN IS REQUIRED TO PERFORM
ELECTRICAL CONNECTIONS.
DANGER – RISK OF ELECTRICAL SHOCK
.
Electrical components for the Rain Deck Controller should be
Installed at least 10 feet (3m) away from any splash pad or water surface. All electrical components should be properly bonded per
national and local codes.
Do not permit any electrical apparatuses (ie. Radio, TV etc.) within 10 feet (3m) of splash pad surface.
Installation Instructions
Caution:
•
Prior to beginning the controller installation make sure it is not plugged into any outlets and
has been disconnected from all electrical connections.
•
The controller must be installed in a shaded area and out of direct sun light.
•
Do not make contact with any components inside the controller other than the green
connector.
Tools required:
Drill (for mounting controller)
#2 Phillips head screw driver
Miniature flat head screw driver
Wire stripper
Wire cutter
Warning
Max allowable current draw per solenoid output is .3 amps.
The Rain Deck Controller must be connected to a supply circuit that is protected by
a ground fault circuit interrupter (GFCI).
A GFCI is generally a minimum code requirement. A
GFCI is required by most building codes and must be tested before each use. The installer should consult the
GFCI manufacturers’ instructions for correct installation and operation. All electrical components should be
properly bonded per national and local codes.
