GTS-TH-V Thermostat Instructions
ver 1.0
See overleaf for further setting up information
Page1
Configuration Menu
To enter into the setting menu please follow the steps below:
Step 1
, Turn the thermostat off by pressing ;
Step 2
, Press
, you will then see menu 1. At this step, if you press and hold “MENU”, you will access to MENU 4 directly.
Step 3
, Use the up and down arrows to adjust the “sensor selection” which is Menu 1(Air sensing, Air and Floor, or Floor only)
Step 4
, Press
to move to the next Menu and once you have all the menu options set,
Setp 5
, Press
to accept and store.
Menu # Feature
Explanation
Adjustment
（
press up & down buttons to adjust
）
1
Mode/Sensor selection
This thermostat is a combination model which allows you to
choose 3 different modes.
A mode=Air Sensing Only(Has built in sensor)
AF mode=Air & Floor sensing(Floor probe must be installed)
F mode=Floor Sensing(Floor probe must be installed)
A, AF, F (F by default)
2
3
4
Maximum Floor Temp
( AF mode only)
This is to protect the floor surface.
20 °C~ 40 °C (28 °C by default)
5+2 / 7 Day Mode
This allows you to program either 5 days at once, then the 2
days of the weekend separately, or a full 7 days at the same
time or 7 days separately
01 = 5+2 day programmable
02 = 7 day programmable(by default)
NEXT
MENU
DONE
Power on Your Thermostat
Then press button to turn on/off the thermostat. When your thermostat is turned off, the LCD will display OFF.
When your thermostat is first connected to mains power, wait for about 30 seconds until the touch pad has self-adjusted.
POWER
POWER
Reset
This allows you to reset your thermostat to factory default
Press and hold the down button until you see RES on screen
LCD symbols
Symbol
Event
The buttons are locked
Heating is turned on
Program number
Set temperature
Symbol
AUTO
Er
Automatic mode,
executes the programmed schedules
Event
Temporary temperature override
Increase
The floor sensor is not being read by the thermostat
OVERRIDE
Decrease
Manual mode
1,2,3,4
