FFLED 120W INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: [email protected]
®
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding
is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A
PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
SLIPFITTER MOUNTING
1.
The slipfitter mounting fits a 2 3/8” O.D.
Tenon
. Place the
slipfitter over the
Tenon
and secure the fixture with the
Set Screws
on the side of the
Slipfitter
.
2.
To adjust the angle of the
Slipfitter
, remove screws and
plug on
Round Cover Plate
. Remove the
Round Cover
Plate
. Loosen the
Locking Bolt
and adjust the angle of
the fixture as desired.
3.
Feed supply wires from
Tenon
to
Slipfitter
and make
necessary connections in the
Slipfitter
and knot wires for
strain relief.
4.
Tighten the
Locking Bolt
and re-attach
Round Cover
Plate
. Seal plug on side of
Round Cover plate
with
Teflon Tape or silicone sealant.
TRUNNION MOUNTING
CAUTION
:
UL and C-UL listed or CSA certified liquid tight
cord grip suitable for use with STW flexible cord shall be
used for connection to a wet location outlet box provided
by others.
To adjust the angle of the fixture using the trunnion:
1.
Loosen the
Pivot Bolts
& angle locking screw.
2.
Adjust fixture to desired angle.
3.
Tighten
Pivot Bolts
& angle locking screw.
Locking
Bolt
Round Cover Plate
Pivot Bolts
FFLED Trunnion
FFLED Slipfitter
Set Screws
Tenon
Slipfitter
WARNING: RISK OF SERIOUS INJURY OR DEATH!
DO NOT MOUNT THE SLIPFITTER TO A TENON OR BRACKET THAT IS MORE THAN 20 DEGREES FROM VERTICAL. MOUNTING
AT ANY ANGLE OTHER THAN 0-20 DEGREES INCREASES THE RISK OF DISENGAGEMENT AND/OR FAILURE OF THE
SLIPFITTER. INSTALL THE POLE ON A SECURE BASE OR INSTALL THE BRACKET TO A WALL FIRST. THEN PLACE LUMINAIRE
ONTO THE POLE OR BRACKET. DO NOT LIFT LUMINAIRE ASSEMBLED TO POLE OR BRACKET. LUMINAIRE MAY DISENGAGE.
