Quoizel, Inc.
6 Corporate Parkway
Goose Creek, SC 29445
Customer Service
Phone 631.273.2700
Fax
631.231.7102
www.quoizel.com
Please go to
for product cleaning tips. Go to the
selection.
www.quoizel.com
Care + Maintenance
Tools Required:
Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape,
safety glasses.
Estimated Assembly Time:
30-45 minutes
Preparation:
Identify and inspect all parts before beginning installation. Check package content list and diagrams
below to be sure all parts are present. If any parts are missing or damaged, do not attempt to assemble, install, or
operate the fixture. Contact customer service for replacement parts.
Warnings and Cautions
1of2
Assembly Instruction Sheet #IS-Q1770F
For Styles Q1770F,Q1771FPN,Q1772FB
Light Source:
(3) A19 Medium Base 60W Bulb Maximum, Alternate bulb (3) 13W CFL
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
,
.
.
.
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at www.quoizel.com
2015 QuoizelInc.
July2015
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject
glass parts to any shock while in operation or shattering July result.
Package Contents
A
B
C
D
E
Loop
x 1
Shade
x 1
Socket
Assembly
x 3
Center
Column
x 1
Rod with
Connector
x 1
STEP 1
Install Rods, Center Column
and Socket Assembly
-
A. Thread the Socket Assembly (C), the
Center Column (D), the Rod with
Connector (E), the Rod (F) and the Base
(G) together as shown. Hand tighten until
snug.
B. Pull the cord from the Base (G) as you
assemble the parts together to remove
the excess cord between parts.
Figure 1
C
D
STEP 2
Install Shade
-
A. Attach the Shade (B) over the nipple
on the top center of the Socket
Assembly (C) and secure with the
Loop(A). Hand tighten until snug.
Figure 2
B
C
A
F
Rod
x 1
G
Base
x 1
E
F
Cord
STEP 3
Install Bulb
-
A. This fixture uses standard bulb with
medium base . Maximum 60 watts.
B. Insert bulb and screw snugly into
place.
Your fixture is now assembled and
ready to use. Enjoy!
Figure 3
Bulb
G
