Warnings and Cautions
1of2
Assembly Instruction Sheet #IS-CSE8410
_R1
For Styles CSE8410PN and CSE8410EK
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Please go to
for product cleaning tips. Go to the
selection.
(1) Medium Base 150W bulb Maximum or
(1) Medium Base Vintage Bulb is recommended but not supplied.
20-30 minutes
Identify and inspect all parts before beginning installation. Check package content list and diagrams below to be sure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact customer service for replacement
parts.
www.quoizel.com
Care + Maintenance
Light Source:
Estimated Assembly Time:
Preparation:
Fixture can only be mounted in the direction indicated on page 2.
Tools Required:
Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
or visit us on-line at www.quoizel.com
Package Contents
A
Crossbar Assembly
x 1
C
Fixture
Body
x 1
B
D
Shade
x 1
E
Steel
Collar
x 1
Socket
Collar
x 1
STEP 1
Install Crossbar Assembly
-
A. Pass the supply wires through the Crossbar Assembly (A). Attach
the Crossbar Assembly (A) to the Outlet Box with the head of the
Green Ground Screw facing you. Secure it with Outlet Box Screws
(not included). Tighten until snug
.
Figure 1
STEP 2
-
Remove Styrofoam
inside of the Fixture Body
A. Remove the Styrofoam and
Shade (C) inside the Fixture
Body (B).
Figure 2
STEP 3
Test Fitting Backplate to Crossbar Assembly
-
A. Remove mounting balls from the Crossbar Assembly (A). Fit the
backplate on Fixture Body (B) to the Crossbar Assembly (A) and
secure with mounting balls. Note: The backplate on Fixture Body (B)
should be snug against the wall and the Mounting balls. If not, adjust
the length of the mounting screws on the Crossbar Assembly (A) by
unscrewing the preassembled hex nut and lock washer and then
screwing the mounting screws in or out of the crossbar until the
correct length is achieved. Once the backplate on Fixture Body (B) is
secure, remove the mounting ball and Fixture Body (B).
Figure 3
2017 QuoizelInc.
RevisedDate:2017-11-03
B
C
Styrofoam
B
Mounting Ball
A
Backplate
Hex Nut and
Lock Washer
Mounting Screw
Supply Wires with
Ground Wire
Outlet Box Screws
(not included)
Outlet Box
A
