IMPORTANT SAFETY INFORMATION
•
Ascend should be installed by a qualified electrician and used in accordance with appropriate
electrical codes and regulations.
•
Read all instructions and warnings prior to using Ascend. Failure to comply with instructions
and warnings constitutes improper use of Ascend.
•
Quirky Inc. is not responsible for improper use of Ascend which may result in personal injury,
product damage, excess heat, toxic fumes, fire, or explosion. Quirky Inc. is not responsible for
any damages one may suffer as a result of use, intended or unintended.
•
DANGER:
VISIBLE LASER RADIATION. AVOID DIRECT EXPOSURE TO BEAM. Ascend
uses a Class 3R laser which emits output power of a maximum 3 mW and 650 nm wavelengths
under IEC60825-1:2007. The laser is harmful to the body, especially eyes, directly or indirectly.
Never stand between the laser and the reflector, or place your eye directly in-line with the
laser source.
•
WARNING:
RISK OF ELECTRIC SHOCK. Use only in dry, indoor locations. This device has
a grounding type plug, that has a third (grounding) pin. This plug will only fit into a grounding
type outlet. If the plug does not fit into the outlet, contact a qualified electrician to install the
proper outlet. Do not change the plug in any way. Proper grounding and a grounding-type
receptacle for connection to the supply is required.
•
WARNING:
RISK OF FIRE. Do not exceed electrical ratings.
•
WARNING:
RISK OF SEVERE INJURY OR DEATH. MAKE SURE YOUR GARAGE DOOR
IS WORKING PROPERLY BEFORE INSTALLING ASCEND. Do not use with improperly
installed/balanced/lubricated or non-functioning garage doors and garage door openers. DO
NOT USE WITH A ONE-PIECE DOOR. Ascend provides an unattended closing function and
should only be used with sectional doors.
•
WARNING:
EYE HAZARD. The use of optical instruments such as, but not limited to,
telescopes or transits to view the laser beam will increase eye hazard.
•
CAUTION:
There are labels on Ascend that indicate where the level emits the laser light. BE
AWARE of the laser light location when using. ALWAYS MAKE SURE that any bystanders in
the vicinity of use are made aware of the dangers of looking directly into the laser.
•
ALWAYS turn the calibration level off when not in use. Leaving the laser on increases the risk of
someone inadvertently staring into the laser beam.
•
DO NOT operate Ascend or calibrate the laser in combustible areas such as in the presence of
flammable liquids, gases, or dust.
•
DO NOT aim the laser on surfaces such as sheet steel that have a shiny, reflective surface. The
shiny surface could reflect the beam back at the operator. Be aware that laser light reflected
off a mirror or any other reflective surfaces can also be dangerous.
•
DO NOT attempt to modify the performance of this laser device in any way. This may result in
a dangerous exposure to laser radiation.
•
DO NOT attempt to repair or disassemble the laser level. If unqualified persons attempt to
repair this laser product, serious injury may result. Any repair required on this laser product
should be performed by authorized service center personnel.
•
For further information regarding lasers, refer to ANSI-Z136.1 the STANDARD FOR THE SAFE
USE OF LASERS, available from the Laser Institute of America (407) 380-1553.
•
Before installing Ascend, UNPLUG existing garage door opener from power source. NEVER
connect garage door opener to power source until instructed to do so.
•
Keep away from children. NEVER permit children to operate or play with Ascend or the Wink
app controlling Ascend.
•
Only use with UL-listed Garage door openers manufactured on or after 1/1/93 that use
photoelectric sensors. Do not use in combination with any other device.
•
There are no user-serviceable parts. Do not attempt to disassemble or modify any part
of Ascend.
•
Ensure switch wires and power cords are routed so as not to interfere with the mechanical
operation of the garage door.
•
This device is intended for installation and use in accordance with the National Electric Code
(NEC) and local regulations in the United States, or the Canadian Electrical Code (CEC) and
local regulations in Canada. Ascend should be installed by a qualified electrician.
•
Important: For the installation and adjustment procedures required to effect proper operation
of the safety means included, refer to your garage door operator’s manual for details.
•
No maintenance is required.
•
Calibrate the laser part regularly, refer to the “Calibrating and Using Ascend” section for
details.
LOCATION OF LASER WARNING, EXPLANATORY
AND APERTURE LABELS
COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Caution: Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance
20cm between the radiator and your body.
This device complies with Industry Canada license exempt RSS standard(s). Operation
is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body.
IN THE BOX
• Smart garage door controller kit with power cable, trigger wires,
mounting bracket, and reflector with adhesive
• 4 drywall anchors
• 4 screws
• 2 spade terminals
• User guide
WHAT YOU’LL NEED
• A UL-listed garage door opener manufactured on or after 1/1/93
that uses photoelectric sensors. Not compatible with newer
Chamberlain® and Liftmaster® S2.0™ encrypted garage
door openers (manufactured after 2011).
• Apple iPhone®, iPod touch®, or Android™ phone
• The Wink app downloaded to your mobile device from
the iTunes® App Store or Google Play™
• A Wi-Fi® network connection with a strong signal in your garage.
A Wi-Fi extender may be necessary.
• Slotted screwdriver
• Pliers
CONNECTING ASCEND TO YOUR WI-FI NETWORK
• Plug the Ascend power cable into any AC outlet (the outlet
does not have to be in the garage at this stage). Ascend will
automatically turn on.
• Open the Wink app on your mobile device and log in with your
email address and password. If this is your first time using the
Wink app, tap “Sign Up” to create an account.
• Tap “Add a product” then “Garage Doors” then “Quirky Ascend.”
• Tap “Start countdown” and hold your phone next to the blinking
sensor on Ascend.
• When your device beeps or vibrates, and the Wink app displays
“Success,” your device is connected and the light on Ascend will
switch from red to green.
• Unplug Ascend from the AC outlet.
R-IN
S-A
CN
D-B
K02 | r
ev0
30
315
Ascend was invented by Nathan Firth,
a web app developer from San Marcos, CA.
Ever the entrepreneur, Nathan dreamed
up the idea for Ascend several years ago.
After meeting with an electrical engineer,
he decided the road to invention was a rough
one to travel down alone. So he submitted
his idea to Quirky and—just like that—
Ascend became a reality. Glad we could
open that door for ya, Nathan!
INVENTED BY
Nathan Firth
+3046 INFLUENCERS
• Allows you to open and close one garage door from your mobile device
• Lets you monitor your garage door status and receive alerts via the Wink app
• The app allows for multiple users, so you can give access to friends or family members
• Your existing garage door opener will remain fully functional
For residential use only.
ELECTRICAL RATING: 120VAC, 60Hz, 15A (passthrough to power existing opener)
Not compatible with newer Chamberlain® and Liftmaster® S2.0™ encrypted
garage door openers (manufactured after 2011).
SMART GARAGE DOOR
CONTROLLER
ASCEND
LIMITED ONE-YEAR
WARRANTY
Quirky, Inc. (“Quirky”) Original Purchase Product
Warranty
Quirky warrants to the original purchaser (“Purchaser”) of this
Quirky product, for the period of one (1) year following the date on
which Purchaser purchases the product, that the product shall be free
of defects in design, assembly, material, or workmanship.
Quirky will refund or replace, at its option, any defective product free of charge.
In order to qualify for this warranty, the Purchaser must provide the defective product
and a copy of the original receipt of purchase to Quirky for inspection. The receipt of
purchase must indicate the product purchased, price paid, date of purchase, and name
of merchant.
To request service under this warranty, contact Quirky at 866-5-QUIRKY or questions@
quirky.com and a Quirky representative will provide instruction on how to proceed.
This warranty shall be null and void if Quirky determines that the product has been improperly
installed, altered or tampered with in any way. This warranty does not protect against normal
use, wear and tear, or damage due to abuse.
THIS WARRANTY CONTAINS THE SOLE WARRANTY OF QUIRKY. THERE ARE
NO OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING THE IMPLIED
WARRANTY OR CONDITION OF QUALITY, MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE, AND SUCH IMPLIED WARRANTIES, IF ANY,
ARE LIMITED IN DURATION TO THE TERM OF THIS WARRANTY. IN NO EVENT
SHALL QUIRKY BE LIABLE FOR INCIDENTAL, SPECIAL, DIRECT, INDIRECT OR
CONSEQUENTIAL DAMAGES SUCH AS, BUT NOT LIMITED TO, LOST BUSINESS
OR PROFITS ARISING OUT OF THE SALE OR USE OF ANY QUIRKY PRODUCT,
EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
Some jurisdictions do not allow exclusions or limitations on implied warranties or incidental,
consequential or other damages, so the above exclusions and limitations may not apply to you.
COPYRIGHT AND TRADEMARK NOTICES
© 2015 Quirky, Inc. All rights reserved.
Quirky is a registered trademark of Quirky, Inc.
Wink is a trademark of Wink, Inc.
GE is a registered trademark of General Electric Company and is under license by Quirky, Inc.
Wi-Fi is a registered trademark of the Wi-Fi Alliance.
ZigBee is a registered trademark of ZigBee Alliance.
Apple, iPod touch, iTunes, and iPhone are registered trademarks of Apple, Inc.
App Store is a service mark of Apple, Inc.
Android and Google Play are trademarks of Google, Inc.
Chamberlain and Liftmaster are registered trademarks of The Chamberlain Group, Inc.
SUPPORT
Need help?
Email [email protected]
Call 1-866-5QUIRKY
