Quick 8801, Operation Manual

Page: 1 / 8

Quick 8801
系列数控伺服控制系统使用说明书
Digital Servo Control System Operation Manual
安全操作指南
General safety instructions
在使用前，一定要仔细阅读本操作指南与所搭配的缝制机械说明书，配合正确使用，并须由接受过专业培
训的人员来安装或操作。在使用或安装本机器时，请注意下列事项。
Please read this manual carefully, also with related manual for the machine head before use. For perfect operation
safety
，
installing and operating this product by trained personnel is required. When install and operate this product,
precaution must be taken as following.
1
．请尽量远离电弧焊接设备或电波发射器等，以免产生的电磁波干扰本控制器而发生误动作。
2
．请不要在室温
45°C
以上或者
0°C
以下的场所使用。
3 .
请不要在湿度
30%
以下或者
95%
以上或者有露水和酸雾的场所使用。
4
．安装控制箱及其他部件时，请先关闭电源并拔掉电源插头。
5
．为防止干扰或漏电事故，请做好接地工程，电源线的接地线必须以牢固方式与大地有效连接。
6
．所有维修用的零部件，须由本公司提供或认可，方可使用。
7
．修理及保养作业，要请经过培训的技术员执行。在进行任何保养维修动作前，必须关闭电源并拔掉电
源插头。控制箱里有高压危险，必须关闭电源五分钟后方可打开控制箱。
8
．本手册中标有 符号之处为安全注意点，必须注意并严格遵守，以免造成不必要的损害。
1. To avoid the false by electromagnetic interference ,Please keep the product away from arc welding
equipment or electro pulse generator.
2. Please don’t operate in room temperature is above 45°C or under 0°C ·
3.Please don’t operate in room humidity is below 30% or above 95% or dew and mist of places.
4. Install the control box and other components, turn off the power and unplug the power cord.
5.To prevent interference or leakage accidents, please do the ground work, the power cord ground
wire must be securely connected to an effective way to earth.
6.All parts for the repair provided by the Company or approved before use.
7. Maintenance and Repairs must be done by specially trained personnel.Performing any maintenance
action, you must turn off the power and unplug the power cord. There are dangerous high voltage
control box, you must turn the power off and wait five minutes before opening the control box.
8.This manual marked with the symbol of the Department of Safety Precautions must be aware of and
strictly adhered to, so as not to cause unnecessary damage.
1.
电控箱安装
Installation of Controller
(1)
安装电机转子
Install the Motor’s Rotor
将电机转子前端面调整到与后套端面间距
1mm
，后用
3mm
内六角扳手拧紧转子螺钉，转
子有一颗螺钉要对准上轴平面。