Qubino
Flush On/Off Thermostat 2
Quickstart
This is a
secure HVAC-Thermostat
for
Europe
. To run this device please connect it to your mains power
supply. To add this device to your network execute the following action:
SmartStart Inclusion
1. Scan QR code on device label and add S2 DSK to Provisioning List in Gateway (hub)
2. Connect the device to the power supply (with the temperature sensor already connected).
3. Inclusion will be initiated automatically within few seconds of connection to the power supply and the device will
automatically enroll in your network (when the device is excluded and connected to the power supply it
automatically enters the LEARN MODE state).
Classic Inclusion
1. Enable add/remove mode on your Z-Wave gateway (hub)
2. Connect the device to the power supply (with the temperature sensor already connected*)
3. Toggle the switch connected to the I1 terminal 3 times within 3 seconds (The device has to get On/Off signal 3
times, meaning 3 times click on the push button or with the normal button 3 times On/Off.) (this procedure puts
the device in LEARN MODE) in the first minute after power cycle.
OR
If the device is powered by 24 V SELV supply, press and hold the S (Service) button between 3 and 6 seconds
(this procedure puts the device in LEARN MODE)
4. A new device will appear on your dashboard
5. Inclusion with the switch connected to I1 terminal is not limited by time
*If connecting the temperature sensor, switch off the power supply.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or
may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage