WARNING:
These instructions must be provided to the user and installer of this equipment. The user and installer of
this equipment must read and understand these instructions before use or installation. Follow the manufacturer’s
instructions for other safety equipment used with this system. Follow these instructions for proper use,
inspection, and maintenance of this equipment. This product is intended to be used as a part of a complete Cabloc
ladder safety system. Alterations, substitutions, or misuse of this equipment, or failure to follow instructions,
may result in serious injury or death.
IMPORTANT:
If you have questions on the installation, use, maintenance, or suitability of this equipment for
your application, contact PROTECTA.
IMPORTANT:
Before using this equipment, record the product identi
fi
cation information from the installation and
service label in the “Inspection and Maintenance Log” at the back of this manual.
Figure 1 - Cabloc Detachable Cable Sleeves
7 x 19 Constructed
Steel Cable
(Carrier Cable)
Cable
Installation
Slot
Cable Shoe
Attachment
Point
Brake Lever
Carabiner
Sleeve
Body
Model
Cable Dia. Safety Standard
Anti-Inversion
AC350A
5/16”
(8 mm)
ANSI A14.3
AC351A
3/8 “
(9.5 mm)
ANSI A14.3
AC350C
5/16”
(8 mm)
CSA Z259.2.1
√
AC351C
3/8 “
(9.5 mm)
CSA Z259.2.1
√
7 X 19 CABLE ONLY:
Cabloc Cable Sleeves shall only
be used on 7 x 19 constructed cable of the diameters
speci
fi
ed above.
1.0 APPLICATIONS
1.1 PURPOSE:
The Cabloc detachable cable sleeve is designed to arrest the fall of personnel while climbing a
fi
xed ladder. The detachable cable sleeve is not intended to be used for material handling.
NOTE:
The installer and user must ensure the ladder meets all applicable local, state, and federal
standards, including ANSI A14.3.
1.2 LIMITATIONS:
Cabloc detachable cable sleeves must be used with a PROTECTA approved ladder safety
system. Use only the Cabloc Sleeve model speci
fi
ed in Figure 1 for you applicable cable diameter and safety
standard(s). The Cabloc cable sleeve must be directly connected to an approved full body harness with the
carabiner supplied with the sleeve (see Figure 1). Do not use connection devices other than the supplied
carabiner. Do not add additional connectors or lanyards between the user and the cable sleeve.
NOTE:
ANSI A14.3 and OSHA 1926.1053 states that the length of connection between the carrier cable
and attachment point on the full body harness must not exceed 9 in. (0.2 m) in Canada per CSA Z 259.2.1-98.
1.3
Refer to applicable local, state, and federal (OSHA) requirements governing this equipment for more
information on ladder safety systems and associated components, including OSHA 1910.27.
User Instruction Manual Cabloc
Detachable Cable Sleeve
This manual is intended to be used as part of an employee training program as recommended by OSHA.
Instructions for the following series products:
LADDER CLIMBING CABLE SLEEVE
Model Numbers: See Figure 1
© Copyright 2012, Capital Safety
Form No: 5902216 Rev: F
