![background image](http://html1.mh-extra.com/html/preview/worksight-wws7020-b/worksight-wws7020-b_quick-installation-manual_1599555001.webp)
WWS7020-B WorkSight
®
System
QUICK INSTALLATION GUIDE
1
10335 W Emerald St
Boise, ID 83704
Phone 1.208.323.1000
Powered by
DOC. # 3700275A
10335 W Emerald St
Boise, ID 83704
Phone 1.208.323.1000
Powered by
Contents:
WWS7220 Sensor (1)
Sensor Mounting Hardware (1)
WSZ-BK90 Sensor Bracket (1)
A/BK Hardware (1)
WD7102 Display (1)
Display Mounting Assembly: (1) each Mounting Arm, Mounting
Ball, Adhesive Base (Assembly required)
Cables (1)
WWS71PA Cable 6.5’/2.0M (1), WD71PA Cable 6’/1.8M (1)
User Manual and Drill Template
1
Select a location for the sensor approximately 3ft/1M from the ground. Ideally the sensor
should be centered on the rear of the vehicle.
Important!
Before the PreView Sensor is permanently installed to the vehicle, verify the selected
location provides a clear detection zone. Temporarily attach the sensor in the proposed
location, apply power to the system, and verify nothing is detected.
Mounting
The sensor may be mounted directly on the vehicle or attached using the supplied bracket.
Using the drill template, scribe position marks through the holes and drill 1/4” (6mm)
holes centered at the marks. A 1 1/2” diameter clearance hole is required for the sensor
connector and the mating cable. Secure the sensor to the vehicle with the supplied bracket
and hardware. Apply a maximum of 22 in-lbs to secure the sensor.
2
Before You Start
Mount Sensor
Note orientation
:
THIS SIDE UP
3
Contact Technical Support with Questions:
Telephone: 844.787.2327
Web: www.PreView
Radar
.com
Email: [email protected]
The quick install guide is only a supplement to the product manuals. Please read all of the
manuals for complete information and instructions before installing the product.
WWS71PA
Mount Display
Not all hardware shown
Back Page
Detailed Wiring
Diagram
WD7102
Mount the display in a location that is easily viewed by the
driver during vehicle operation. Typical location for the display is
on the dash within reach of the driver, but where it does not
obstruct view of the road or gauges.
WSZ-BK90
Sensor
Hardware
A/BK Bracket
Hardware
WWS7220
WD71PA
Display Mounting
Assembly
RAM-B-237U
RAP-B-378U
RAM-B-201U