Let’s get
connected.
Multi Purpose Switch.
Important - Read before installing.
1
Megger testing may lead to low readings due to electronic components so
disconnect all electronic devices before taking reading. Install the included
warning sticker with circuit detail in the main electrical switch board.
Surge protection is recommended at the main switchboard.
Products damaged by power surges are not covered by warranty.
Powermesh devices must only be connected
with the Active and Neutral from the same RCD.
Failure to follow these
instructions can result in
serious injury or death.
Must only be installed by a
LICENSED ELECTRICIAN
to local wiring regulations.
Switch
Push button switch
for on and off with
LED indicator.
Mounting Screws
Included on rear
of device.
Factory Reset
Press until indicator flashes
blue to restore factory
settings. When the indicator
turns blue, it’s ready to pair.
(remove cover)
Using the Multi Purpose Switch.
2
Powermesh
Status Indicator
See overleaf for the
meaning of each
colour status.
Snap on cover
MAC ID
Unique product
serial number.
(remove cover)
Identifying the switches.
3
LO
AD
1
LO
AD
2
LO
AD
3
LO
AD
4
LO
AD
1
LO
AD
2
LO
AD
3
LO
AD
1
LO
AD
2
LO
AD
1
1 Button
PMMPS1
PMMPS1BK
2 Button
PMMPS2
PMMPS2BK
3 Button
PMMPS3
PMMPS3BK
4 Button
PMMPS4
PMMPS4BK
1
1
1
4
3
2
1
2
2
3
