V1.0
8873259
Please read and understand all instructions before use. Retain this manual for future reference.
SPECIFICATIONS
Load Capacity
600 lb
Dimensions (LxWxH)
59 x 29.5 x 33.8 in.
Material
Steel
Finish
Powder Coating
SAFETY
WARNING! Read and understand all instructions before
using this tool. The operator must follow basic
precautions to reduce the risk of personal injury and/or
damage to the equipment.
Keep this manual for safety warnings, precautions, operating
or inspection and maintenance instructions.
1. Use the correct tool for the job. This tool was designed
for a specific function. Do not modify or alter this tool or
use it for an unintended purpose.
2. Operate in a safe work environment.
3. Always wear impact safety goggles that provide front
and side protection for the eyes. Eye protection
equipment should comply with CSA Z94.3-07 or ANSI
Z87.1 standards based on the type of work performed.
4. Do not overreach when operating a tool. Proper footing
and balance enables better control in unexpected
situations.
UNPACKING
WARNING! Do not operate the tool if any part is missing.
Replace the missing part before operating. Failure to do
so could result in a malfunction and personal injury.
Remove the parts and accessories from the packaging and
inspect for damage. Make sure that all items in the
Identification Key are included.
IDENTIFICATION KEY
A Workbench Top
B
Legs (2)
C
Brace
D Shelf
E
Foot (4)
F
Bolt, M8x45 (16)
G Washer, M8 (16)
H Nuts, M8 (16)
ASSEMBLY/INSTALLATION
All connection use the bolts (F), washers (G) and nuts (H). Do
not fully tighten until the table is assembled. Place the
washer on the bolt before inserting into the table component.
1. Screw each foot (E) into the bottom of the legs (B).
2. Position the brace (C) to overlap the four bolt holes with
the leg bolt holes. Secure with bolts, washers and nuts.
3. Secure the brace to the other leg in the same manner.
4. Place the shelf (D) between the legs. Secure the corners
with bolts, washers and nuts.
5. Place the workbench top (A) onto the table legs so the
bolt holes are overlapping.
6. Secure each corner with bolts, washers and nuts.
7. Tighten all bolts and nuts.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is
efficient, easier to control and will have fewer problems.
2. Inspect the tool components periodically. Repair or
replace damaged or worn components. Only use identical
replacement parts when servicing.
WARNING! Only qualified service personnel should
repair the tool. An improperly repaired tool may present
a hazard to the user and/or others.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool
does not function properly or parts are missing. If unable to
do so, have a qualified technician service the tool.
