RA-7690
LCD ANNUNCIATOR
INSTALLATION SHEET
MKT. #5406017 - REV A
LT-0263-P 7/03
PRINTED IN USA
Potter Electric Signal Company
•
2081 Craig Road, St. Louis, MO, 63146-4161
•
Phone: 800-325-3936/Canada 888-882-1833
•
www.pottersignal.com
DESCRIPTION
The RA-7690 LCD Annunciator provides three 2-button
Panic keys, an AC power LED, 32-character display,
backlit keyboard with easy-to-read lettering, and a built-
in speaker.
INSTALLING THE KEYPAD
The keypad housing is made up of two parts: the
front, which
contains the circuit board and other components, and the
base. To mount the keypad, remove the base from the front
by inserting a flat screwdriver into one of the openings on the
bottom. Twist the screwdriver while pulling the halves apart.
Repeat with the other opening.
The RA-7690 uses the same plastic housing and are de-
signed to easily install on any 4-square box, 3-gang switch
box, or flat surface. Figure 1 shows the mounting hole
locations on the base of the keypad housing.
PAGE 1 OF 4
WIRING THE KEYPAD USING THE WIRING HARNESS
The RA-7690 keypad is supplied with a
4-wire harness for connection to the panel's keypad bus.
Observe the wire colors when connecting the red, yellow,
green, and black wires to the keypad bus. When wiring
directly to the panel terminals, connect the red wire the
terminal 7, the yellow to terminal 8, green to 9, and the black
wire the terminal 10.
Guide Tabs
Reference Card
Back of 692
Keypad Base
Surface and Backbox
Mounting Holes
Combined 4-square
and 3-gang switch box
Mounting Holes
Surface and Backbox
Mounting Holes
Surface and Backbox
Mounting Holes
Red
- 7
Yellow
- 8
Green
- 9
Black
- 10
Figure 1: Back of RA-7692 Keypad
Back of RA-7692
Keypad Base
