MODEL NO.: SSN
– 114H
FEATURES
Medium duty Manual Steel Strap Sealer
Single Notch regular type (Down cut) side action
Easy to operate & maintain
SPECIFICATIONS
Strap Thickness
: 0.79 mm
– 0.89 mm / 0.031” – 0.035”
Strap width
: 31.75mm /
11/4”
Grade
: Regular Duty or High Tensile.
Joint Efficiency
: 75% to 80%
Weight
: 3.700 kg / 8.15 lb
Dimension (L X W X H)
:
745 x 48 x 278 mm / 29.3”x1.9”x10.9”
OPERATIONAL MANUAL
1. Hold the `SSN-114H` vertically, opened the Jaws & place the jaws across of the seal. This step is
very important as a seal crimped of the off-center may cause the strap to become loose & snap
apart, possibly resulting in serious injury or death.
2. Press the handle of the sealer together until the proper sealing done, while keeping the sealer in
vertical position.
3. Remove the sealer & inspect the seal to verify the seal is properly holding the strap. The seal should
have two impressions, one on each side. The notches should be centered on the seal. If seal isn`t
properly formed, remove it & do it again with new seal & strap. Attempting to reseal will not ensure a
proper seal & will decrease the break strength.
4.
Never use the sealer to break the strap. Breaking the strap without the proper cutter may cause the
strap to snap back towards the operator, possibly resulting in serious injury or death. This action will
also cause damage to the sealer, which will require the sealer to be repaired or replaced at owner`s
expense.
