MODEL NO: SMDR-32
FEATURES
Medium duty Manual Steel Strap Sealer.
Double Notch reverse type (up cut) side action.
Easy to operate & maintain
High strength Aluminium-alloy handle used
SPECIFICATIONS
Strap Thickness
: 0.79 mm
– 0.89 mm / 0.031” – 0.035”
Strap width
:
31.75mm / 11/4”
Grade
: Regular Duty or High Tensile.
Joint Efficiency
: 75% to 80%
Weight
: 3.9 kg / 8.59 lb
Dimension (L X W X H) :
750 x 65 x 165 mm / 29.5”x 2.5” x 6.5”
OPERATIONAL MANUAL
1. Hold the `SMDR-32` vertically, opened the Jaws & place the jaws across the
seal. This seal is very important as the seal crimped the off-center may cause the
strap become loose & snap apart, possibly resulting in serious injury.
2. Press the handle of the sealer together until the proper sealing operation done,
while keeping the sealer in vertical position.
3. Remove the sealer & inspect the seal to verify the seal is properly holding the
strap. The seal should have four impressions, two on each side. The notches
should be centered on the seal. If impression isn`t properly formed, remove it &
do it again with new seal & strap. Attempting to reseal in previous seal will not
ensure a proper seal & will decrease the break strength.
4.
Never use the sealer to break the strap. Breaking the strap without the proper
cutter may cause the strap to snap back towards the operator, possibly resulting
in serious injury. This action will also cause damage to the sealer, which will
require the sealer to be repaired or replaced at owner`s expense.
