Sonicare toothbrush
HX6150, Sanitizer
HX6902, FlexCare
HX6911, FlexCare
HX6912, FlexCare with Sanitizer
HX6930, (handle)
HX6932, FlexCare with Sanitizer
HX6952, FlexCare with Sanitizer
Published by Philips Consumer Lifestyle
Printed in the Netherlands
© Copyright Reserved
Subject to modification
4235-057-54241 _ 11-05-12
(YY_MM_DD)
Philips Domestic Appliance and Personal Care
SERVICE POLICY
Product will be serviced for 3 years after End of Life.
PRODUCT INFORMATION
Easy-start
The brushing power will gently increase to full power over the
first 14 brushings.
The Easy-start feature is active if you hear 2 beeps immediately
after turning on your toothbrush.
Once you reach the optimal brushing power, after the 14
th
brushing, you will no longer hear the double beep at the
beginning of the brushing routine.
Easy-start can also be switched off. To deactivate and to
reactivate the Easy-start feature, see directions for use.
Smartimer
Automatically sets the brushing time to 2 minutes.
After these 2 minutes the product switches off automatically.
If you wish to pause, or stop brushing during the 2- minute
cycle, press the on/off button. When you press the on/off button
again, the Smartimer will pick up where you left off.
Quadpacer
The Quadpacer feature ensures that you brush all four sections
of your mouth evenly and thoroughly. You will hear a short
beep and notice a brief pause in brushing action. This is the
signal to move to the next section of your mouth. To deactivate
and to reactivate the Quadpacer feature, see directions for use.
Programmable brushing modes
The programmable brushing allow you to customize the
brushing action. There are three different brushing modes.
Service Manual
Clean mode is the standard mode for superior teeth cleaning.
Sensitive mode provides gentle, yet thorough cleaning for
sensitive gums and teeth.
Massage mode provides gentle gum stimulation. .
Programmable
brushing
routines
The programmable brushing modes and routines allow you to
customize the length of brushing time. Choose 1, 2(factory
default) or 3 minute time intervals.
The 1-minute Go Care brushing routine has Quadpacer beeps
every 15 seconds.
The 2-minute Clean brushing routine has Quadpacer beeps
every 30 seconds.
The 3-minute Max Care brushing routine has Quadpacer beeps
every 45 seconds.
Note: The Quadpacer feature cannot be deactivated on the Go
Care and Max Care brushing routines.
Reminder bristles
Reminder bristles are introduced to remind the consumer to
replace their BHs at the recommended replacement time
.
The color of the reminder bristles wears out as you use the
brush head and starts fading from the tip downward. When the
reminder bristles have faded half way it is time to replace the
brush head. After approximately 3 months of use.
