Pella Rolscreen Installation, Operation And Care Instruction Download

Page: 1 / 5

PARTS REQUIRED:

• Rolscreen Assembly, Guides (LH & RH) and

attachment screws

TOOLS REQUIRED:

• Drill / Driver with

#1 square head bit

• Flat blade screwdriver

Rolscreen® Retractable Screen
for Windows

Installation, Operation and Care Instruction

Part Number: 81VS0100

Please read and understand all the instruction steps before proceeding with Rolscreen installation.

Installing the Screen ................................................. Page 1

Cleaning the Screen ................................................. Page 3

Adjusting Roller Tension ........................................... Page 3

Operating a retractable screen may result in a static discharge. A static discharge in the

presence of a flammable substance such as aerosol lubricant could cause ignition. To

avoid injury and/or property damage, do not use any flammable substance on a retractable screen.

CAUTION

Installing the Screen:

From the interior position the Rolscreen Assembly

at the head of the window.

While holding the assembly in position,

install an attachment screw (be sure to use a

driver with #1 square head bit) at a slight angle up (~25° ) in the hole of the end cap on
each side of the assembly.

NOTICE:

Be sure to use a #1 square head bit when installing or removing the attachment screws.

81VS0100

Summary of Contents for Rolscreen





