For Technical Support: www.panduit.com/resources/install_maintain.asp
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2014
FS098
Page 1 of 2
Caution Label
Laser Warning Label
Grommet
Opticom Rack Mount Fiber Enclosure
Part Number: FRME2
FRME2
1 FRME Enclosure
1 FRME Kit
1 Port I.D. Label
2 Enclosure Brackets
Port I.D. Label
Saddle Clip
Grounding Lug
Bracket
DISCARD
DISCARD
GROMMET CUTTING DIAGRAM
Cut the small
circle for 1"
diameter
innerduct
Cut the large
circle for 1-1/2"
diameter
innerduct
Cut the straight
lines when not
using any
innerduct
Assembly Instructions:
Determine the cable entry location on the enclosure. Remove the knockout
by inserting a screwdriver into the slot located in the center of the knockout
and apply a twisting upward motion, then lift out. Insert grommet following
proper cutting diagram. Snap in saddle clips. Grounding lug attaches to a
stud at the rear, inside the enclosure, on the top or bottom with a #10-32
nut. Apply laser warning label and caution label in a clearly visible location.
Apply port I.D. label(s) on the inside of the door.
