E
N
G
L
I
S
H
2
CQ-DF602W
11
General
E
N
G
L
I
S
H
1
CQ-DF602W
10
Before Reading these Instructions
You can operate this unit by pressing buttons on the main unit and the remote control unit.
∫
These instructions describe buttons that are concerned with operations as follows.
Example: Press [P·SET
"
] or [P·SET
#
]/[
"
] or [
#
].
∫
Some operations can be activated by pressing buttons only on main unit or remote control unit.
Those cases are described in the instructions.
Example: Press [OPEN] on the main unit.
Battery Installation
1
Remove the battery holder.
Pull the battery holder by the position B while pushing
position A in the direction indicated by the arrow.
2
Install the battery on the battery holder.
Set a new battery properly with its “
i
” side facing up
as shown in the figure.
3
Insert the battery holder.
Push the battery holder back into its original position.
Battery Notes
Remove and dispose of an old battery immediately.
Battery Information:
≥
Battery type: Panasonic lithium battery (CR2025) (included)
≥
Battery life:
Approximately 6 months with normal use (at room temperature)
≥
Do not disassemble or short the battery. Do not throw a battery into a fire.
≥
Keep batteries away from children to avoid the risk of accidents.
≥
Be careful to observe proper local disposal rules when you dispose of batteries.
Caution:
≥
Improper use of batteries may cause overheating, an explosion or ignition, resulting in injury or a fire.
Battery leakage may damage the unit.
[buttons on the main unit]/[remote control unit]
Point the remote control unit at the main unit’s sensor.
Remote Control Unit Preparation
Lithium battery
(included)
Back side
Position B
Position A
Battery holder
Note:
≥
When the power is switched on for the
first time, a demonstration message ap-
pears on the display.
To cancel this display, press [DISP] (dis-
play).
ACC
ON
[SOURCE]
(POWER)
[DISP]
(Display)
Power
Turn the key in the ignition until the accessory in-
dicator lights.
ON: Press [SRC] (PWR)/[SOURCE] (POWER).
OFF:Press and hold [SRC] (PWR)/[SOURCE]
(POWER) again for more than 1 second.
≥
After turning off the ignition key, a security
message is displayed, and the panel removable
alarm that reminds you to take the panel is acti-
vated.
(When security function is set to on
➡
page 28)
1
Source
Press [SRC] (SOURCE)/[SOURCE] to change the source.
2
Radio
CD player
CD changer control
AUX-IN setting
(When a CD is in the player.)
(When a CD changer is con-
nected and magazine is in the
changer.) (
➡
page 20)
SRC
DISP
P.SET
CQ-DF602W
N 5
O6
W
X
;
/
1
OPEN
BAND
TUNE
TRACK
PW
R
MU
TE
P
U
S
H
CD RECEIVER WITH FULL DOT MATRIX DISPLAY
DISC
SET/APM
M
EN
U
VOLUME
SO
UR
CE
MOSFET
50W
X
4
Remote control signal sensor
