background image

 
 
 

Panasonic Electric Works Fire & Security Technology Europe AB 

 

Jungmansgatan 12, SE-211 19 Malmö, Sweden 

Tel: +46 (0)40 697 70 00 • Fax: +46 (0)40 697 70 99 

[email protected] • www.panasonic-fire-security.com 

 

Fire alarm systems 

Enclosed 

addressable manual 

call point  

3339 

 

Attractive design compliant with EN54-11.  IP rating IP67 

 

Test key for routine testing without breaking the glass element 

 

Protection against accidental operation 

General 

The call point has an attractive design 
compliant with EN54-11, and is surface 
mounted in the supplied red backbox.  It has 
a clip retained front cover that makes it easy 
to replace the glass element and adds 
security since the clips are concealed.  The 
frangible element is a glass element with a 
protective plastic film.  To operate the call 
point, the glass element is pressed until it is 
broken.  This will activate the built-in 
microswitch, which will generate a fire 
alarm in the c.i.e.   

Test key 

Routine testing is made with a supplied test 
key, without breaking the glass element.  
Inserting the test key simulates the breaking 
of the glass element.  The call point is 
automatically reset when the test key is 
removed.  The test key is also used to 
release the security clips for the front cover. 

Protective cover 

To protect the call point against accidental 
operation, a transparent polycarbonate cover 
has to be lifted to get access to the glass 
element. 

Encapsulated circuit 

All electronics are encapsulated.  Only the 
terminal block is accessible from the rear.  
Mounted in the supplied red backbox and 
the tightening gasket on place (see the 
opposite page), the IP rating is IP67. 

LED indicator 

An LED on the front cover indicates fire 
alarm generated by the call point.  

Flashing LED

:  The LED will flash each 

time the c.i.e. communicates with the call 
point, until the call point is operated and the 
LED is switched on. 

Non-flashing LED

:  The LED is switched 

off until the call point is operated and the 
LED is switched on. 

Connections / Settings 

The COM loop is connected directly to the 
call point via a 4-way terminal block.  For 
COM loop address setting is the address 
setting tool 3314 used.  3314 is also used to 
set the call point type and the LED mode: 

 

NORMAL

 mode:  (EBL512 SW 

version >2.0 / EBL128).  M.c.p. type 
3339. (Flashing or non-flashing LED is 
set via Win512 / Win128.) 

 

2330

 mode:  M.c.p. type 2339, flashing 

LED. 

 

2312

 mode:  M.c.p. type 2339, non-

flashing LED. 

Two flying leads (wires) are connected to 
the terminal block, for connection of the 
3314 address setting tool's connection cable.  
The wires are to be disconnected before the 
COM loop wires are connected. 

Product applications 

Used in the systems EBL512 / 128 / 1000 / 
2000 and is intended for indoor use in 
premises where IP67 rating is required. 

Reviews: