Components
900-0156-01-00 Rev B.vsd\Page-1\2013-06-14
©2013 OutBack Power Technologies. All Rights Reserved.
Contact Technical Support:
Telephone:
+1.360.618.4363
Email:
Website:
www.outbackpower.com
Radian System Products
Major Components
GS7048E Inverter/Charger
GSLC175-AC-230
GS Load Center
GSLC175-AC-230
Inverter/Charger
GS7048E
IMPORTANT:
Not intended for use with
life support equipment.
PV and Grid-Tied
Inverter
Battery Bank
Vented Battery Enclosure
MATE3
System
Display and
Controller
GS Load Center
(GSLC)
System Display
MATE3
MATE3 uses FW-MB3 mounting bracket
MATE3 requires revision 002.015.xxx or higher
Includes Remote Temperature Sensor (RTS)
Optional OutBack Components
FLEXnet DC Monitor
(FN-DC)
Communications
Manager
HUB10.3
HUB10
HUB4
AC Sources
Utility Grid (required)
AC Generator (optional)
Main Electrical Panel
Electrical Distribution Subpanel
(Protected Load Panel)
Battery Bank
Photovoltaic (PV) Array
Customer-Supplied Components
Grid-Tied Inverter, 230 Vac
De-energize/Shutdown Procedures
2a
2b
1
2
1
1b
1c 1d
3a
To de-energize or shut down the AC-coupled system:
1.
Turn off (open) the AC circuit breakers.
2.
Turn off (open) the DC circuit breakers for the battery.
Wait 5 minutes for the inverter to internally discharge itself.
3.
Verify 0 Vdc on the first DC bus of the inverter by placing the voltmeter leads
on and .
4.
Verify 0 Vdc on the second DC bus by placing the voltmeter leads on
and .
5.
Verify 0 Vac on the AC output circuit breakers by placing the voltmeter leads
on
and .
6.
Verify 0 Vac on the grid-tied inverter terminals and .
1
2
Functional Test Points
Battery Voltage Test Points
AC OUT Voltage Test Points
(Terminal bus bar = TBB)
1a
1b
1c
1d
3a
2b
2a
2b
Grid-Tie Inverter Test Points
WARNING: Lethal Voltage
Review the system configuration to identify all possible
sources of energy. Ensure ALL sources of power are
disconnected before performing any installation or
maintenance on this equipment. Confirm that the
terminals are de-energized using a validated voltmeter
(rated for a minimum 1000 Vac and 1000 Vdc) to verify
the de-energized condition.
WARNING: Lethal Voltage
The numbered steps will remove power from the
inverters. However, sources of energy may still be
present inside the GSLC and other locations. To
ensure absolute safety, disconnect ALL power
connections at the source.
WARNING: Burn Hazard
Internal parts can become hot during
operation. Do not remove the cover
during operation or touch any internal
parts. Be sure to allow them
sufficient time to cool down before
attempting to perform any product
maintenance.
2a
2b
3a
2b
1b
1c
1b
1d
2a
2b
3a
2b
AC-Coupled Application
