Push down on pressure safety
cap then turn the cap
anti-clockwise to unscrew.
OPERATING PROCEDURE
The following rules must be observed when using the Robby 6000
Always
Check daily before use that the power supply cable, plug
and sockets are in good condition; check for visible signs of
damage (do not use if damaged)
Never
allow any part of the
Robby 6000
to be immersed in
water
Always
Follow the correct procedure when filling the water
reservoirs and waste tank
Never
allow children, inexperienced, untrained or
unauthorised people access to the
Robby 6000
Always
Wear full PPE when working in confined spaces - mask,
goggles, gloves, overalls.
Push down on the tank cap and
turn it clockwise to screw it shut
firmly.
Switch on the main switch. The boiler ready lamp
(green lamp) will light up when ready for use.
Fill the tank with water using
the funnel :
max. 4 ltr.
Preferably hot water. Make
sure the tank does not overflow.
Operating Procedures on the Robby 6000
Connect the steam hose
to inlet.
Now the machine is ready for
use: Activate the steam
switch.
When hot water is required switch on the right
switch of the pistol grip and the hot
water switch.
Select the required accessory. Push firmly
onto the left switch of the pistol grip and
the trigger (red switch underneath the
pistol grip). It is possible that a small
amount of water is released.
Open the steam output
regulator knob and regulate
it to the required amount of
steam.
