GENERAL
o
These luminaires are used indoors
(
ta 40 C
)
where emergency light is needed.
E a c h l u m i n a i r e m u s t b e p e r m a n e n t l y
connected to mains power supply
.
In normal operation the led strip lights and the
battery is charging.
In case of a mains power supply failure the
luminaire will light the led strip automatically
in emergency mode. When the mains power
supply is restored the device turns to normal
operation.
INSTALLATION
To install the luminaire follow the installation
instructions on page 4.
Battery Cut-off
The luminaire enters in this operation when the
mains power supply fails
and battery has lost
its energy
.
During this operation the luminaire
enters the idle state
and battery consumption is
negligible, in order to be protected from deep
discharge.
Battery charging
The battery charging is completely controled
.
In
this case, is
achieved the perfect battery
maintenance
,
as well as the elongation of its
duration
.
When the battery has completely
charged
,
it charges with a maintenance
current.
Manual
Test
The manual test can be conducted only if the
main power supply and the battery is connected.
By pressing the test button briefly an operation
test is initiated. During this test period all
indication LEDs are OFF.
Automatic test
This test includes all the operations that provide
the manual test and is conducted automatically
every 15 days. In order to be performed, the
main power supply and the battery should be
connected.
Automatic Autonomous Test
The Automatic autonomous Test is conducted
and measures the luminaire`s back up
operation. This test is conducted automatically
every six months
.
In order to be performed, the
main power supply and the battery should be
connected (the battery should be charged)
.
If
the battery is not charged
,
the test is postponed
until the battery is completely charged. If during
the Automatic Autonomous Test the luminaire’s
duration is lower than the named, then the
battery must be replaced.
Back Up Operation
The autonomous duration of battery during
923427000_09_00
5
Page
1
from
5
GR-427/12L SELF TESTING MAINTAINED EMERGENCY LUMINAIRE
220-240V AC/50-60Hz
Bayblend FR3010
,
transparent
polycarbonate
TECHNICAL CHARACTERISTICS
(for LED MODULE Specs. see page
5
)
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
EXTERNAL DIMENSIONS
CONSTRUCTION MATERIALS
TYPICAL WEIGHT
GUARANTEE
OPERATION VOLTAGE
MAXIMUM POWER CONSUMPTION
BATTERY
(
Ni-Cd
)
CHARGING TIME
INDICATIONS
-
CONTROLS
BATTERY PROTECTION
MINIMUM AUTONOMOUS DURATION
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
ILLUMINATION (230V / EMERGENCY)
ILLUMINATION SOURCE
480 min
24h
Charge, lamp fault, fault indication LED
,
TEST button
From overcharge and full discharge
IP42
12 white LED’s
EN 60598-1, EN 60598-2-22
, ΕΝ 55015, ΕΝ 61547, ΕΝ 61000-3-2, ΕΝ 61000-3-3
5 to 40 C
o
Up to 95%
3 years
(1
year for the battery
)
272
x 121 x 50 mm
600gr.
100lm / 100lm
3,6
V/3Ah
3,5
W / 7VA
Thank you for your trust in our products
Olympia Electronics - European manufacturer
