220-240V AC/50-60Hz
Bayblend FR3010
,
transparent
polycarbonate
TECHNICAL CHARACTERISTICS
(for LED MODULE Specs. see page 2)
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
EXTERNAL DIMENSIONS
CONSTRUCTION MATERIALS
TYPICAL WEIGHT
GUARANTEE
OPERATION VOLTAGE
MAXIMUM POWER CONSUMPTION
BATTERY
(
Ni-Cd
)
CHARGING TIME
INDICATIONS
-
CONTROLS
BATTERY PROTECTION
MINIMUM AUTONOMOUS DURATION
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
ILLUMINATION (mains/emergency)
ILLUMINATION SOURCE
24h
Battery charging LED
,
TEST button
From overcharge and deep discharge
5 to 40 C
o
Up to 95%
3 years
(1
year for the battery
)
262
x 100 x 70 mm
White LEDs
3W / 4VA
IP20
3.6V/1Ah
180 min
590gr.
30lm/75lm
EN 60598-1, EN 60598-2-22
, ΕΝ 55015, ΕΝ 61547, ΕΝ 61000-3-2, ΕΝ 61000-3-3
‘’
CLASSIC LIGHT ‘’ SERIES FOR
NON MAINTAINED / MAINTAINED (OPTIONAL) LUMINAIRES
GENERAL
o
These luminaires are used indoors
(
ta 40 C
)
where emergency light
is needed.
Each luminaire must be permanently connected to mains power
supply
.
In normal operation the led strip lights and the battery is charging.
In case of a mains power supply failure the luminaire will light the led
strip automatically in emergency mode. When the mains power
supply is restored the device turns to normal operation.
NON MAINTAINED OPERATION
By default the luminaire operates as maintained. The luminaire has a
possibility to operate as non maintained. To change the maintained
to non maintained operation follow the relative instructions on page
2.
LED STRIP CHECK
(
with
normal power supply in maintained
operation or in emergency operation with the led strip powered
).
By pressing continuously the
(
led strip check)
button, an intentional
disconnection of the led strip is carried out and that is indicated by
the red indication led. When the button is released the indication led
will be turned off
.
So in every disconnection of the led strip, the red
led will indicate it
.
INSTALLATION
To install the luminaire follow the installation instructions on page 2.
ΑΤΤΕΝΤΙΟΝ
!!!
1. Operations for installation, maintainance or testing must be done
by authorized personnel only
.
2.
The device must be connected to the mains power supply through
a fuse dependent by the total amount of the line’s power load
.
3.
It is suggested to check every month the indication LED for battery
charging, and by
pushing the TEST button to check the emergency circuit. The led
strip should: a) light with bigger intensity as long as the TEST button
is pressed (maintained operation),
b) light as long as the TEST button is pressed (non-maintained
operation).
4.
It is suggested to check every 6 months the minimum autononous
duration by disconnecting
the mains power supply
.
Count the time that the led strip lights and
in case of less time than the minimum autonomous duration the
battery must be replaced. If the measured time is considerably less
than the minimum autonomous duration
In case
If the luminaire doesn’t work as described above contact
the installer.
contact the installer.
of battery or led strip replacement, these must be replaced by parts of
the same type
t i
in battery recycling points. Do not
incinerate.
.
5.
In case of inactive use for a period greater than 2 months,
disconnect the battery by pulling out the battery’s connector.
6.
I
s not allowed to discard batteries in to common trash bins,
they must be discarded only
GR-151-3/L
923151004_09_007
Page
1 of
3
Thank you for your trust in our products
Olympia Electronics - European manufacturer
