TWIN-HEAD 500 W HALOGEN WORK LIGHT
IMPORTANT:
Please read this manual carefully before assembly and save it for reference.
Sa
fety
CAUTION: LAMP BECOMES HOT WHEN IN USE.
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, EXCESSIVE UV RADIATION OR PERSONAL INJURY:
1. Turn off, unplug, and allow unit to cool down before replacing light bulb.
2. Lamp gets hot very quickly! Touch only the switch when turning on or off. Do not touch hot lens, guard, or enclosure.
3. Do not remain in front of light if skin feels warm. Do not look directly at lamp.
4. Keep lamp away from materials that may be affected by heat.
5. Use only with the maximum bulb wattage suggested or less.
6. Do not touch bulb with bare hands. If unavoidable, use a soft dry cloth and wipe off oil from skin.
7. Do not use lamp with missing or damaged parts.
8. When using the portable work light outside, basic safety precautions should always be followed:
a) Use only with three-wire outdoor extension cords that have two prongs and ground pin.
b) Ground Fault Circuit Interrupter (GFCI) protection should be used on the circuit(s) or outlet(s) when used in wet locations.
c) Use only with an extension cord for outdoor use: SW, SW-A, SOW, SOW-A, STW, STW-A, STOW, STOW-A, SJW-A, SJOW,
SJOW-A, SJTW, SJTW-A, SJTOW, or SJTOW-A.
ASSEMBLY INSTRUCTIONS
1) Fasten the grill guard to the
light head:
a. Unscrew the face plate
from the housing.
b. Insert the grill guard
between the face plate and
the glass lens.
c. Screw the face plate back
to the housing.
2) Using screws supplied, secure handles to the top of the lamp housing.
3) To mount lamps to the crossbar, insert washer between crossbar and mounting
bracket. Insert screw through crossbar washer and mounting bracket holes. Using
the knobs, secure together.
4) Attach the lamp assembly to the post and secure with the washer and adjusting
knob.
5) To open and adjust the legs, loosen the knob then push down the slider and
retighten the knob.
6) To adjust the post height, loosen and tighten the lock nuts located at each extension
of the post.
model no. 052-4058-6 | contact us: 1-866-827-4985
For indoor and outdoor use
Retain carton for storage purposes
Instruction Manual
Bulb Installation
BULB INSTALLATION
1) Make sure to replace the bulb with the same wattage or lower (500 watts).
2) Disconnect power and allow lamp and bulb to cool down.
3) Unscrew wingnut and remove handle.
4) Remove top face plate attachment screw.
5) To open, pull face plate down.
6) To remove old bulb, push light bulb to the right and pull out.
7) Holding the new bulb by the ceramic ends, insert bulb socket onto the right end side first, then gently push on the left
end socket. Do not turn power on with face plate open.
MADE IN CHINA
Imported by Noma Canada
Toronto, Canada M4S 2B8
b
a
c
Locking pin
6
